Pilatus Porter Plans Rev1.3
-
Upload
marcel-van-ramshorst -
Category
Documents
-
view
169 -
download
6
Transcript of Pilatus Porter Plans Rev1.3
A A1
A A1
F1
F2
F3 F4
Rear Fuse Side
Front Fuse Side
Pilatus Porter Copyright©2005 RC Airplane Advisor
(1/8 in)
(1/16 in)
F1
F2
F3
F4
F5
X = strut attachment
(1/16 in)(1/16 in) cross-grain
sheeting from F1 to F2
balance point18 mm from leading edge
join front & rearpatterns at A-A1
balsa thickness =1/32 in unless noted
1/32 ply gear leg reinforcement
1/32 ply reinforcement
formers wood grain
rear peglocation(1/8 dowel)
turn spinner frombalsa block
drill small hole;silicone glue
secu
re w
/ sc
rew
ply
pla
te
x
fuse cross-pieces1/16 square balsafour (4)
Right Horizontal Stab
Rt Elevator Half
Pilatus Porter Copyright©2005 RC Airplane Advisor
Wing Ribs
12
1/32" wire
Wrap with copper wire,then solder
1/8 in
end-piece wood grain
join elevator halves with 1/32 wire15mm gap
glue & tape
glue
3
1, 2
4 4
Wheel retainers:heat-shrink tube, orwrap and solder
front view of 3
actual pattern of 3
Right Wing
Left Wing
Vertical Stab and RudderAssembly
Pilatus Porter Copyright©2005 RC Airplane Advisor
Wing Rib Locations
X = Strut Location
Dihedral = 1" each wing tip
end-piece wood grain
Wing Struts(1/16 in)
Pilatus Porter Copyright©2005 RC Airplane Advisor
1) Balsa thickness = 1/32 in unless noted. Prototype used Sig contest balsa (4-6lb) for 1/32 sheet.
2) Power = One 12-inch loop of 1/8 in rubber
3) Prop = 4 in plastic (from Guillows "Sleek Streak" or similar)
4) Horizontal stab 2 degrees negative incidence relative to wing
5) Center of gravity 18mm from leading edge of wing
6) Hinge control surfaces with copper wire and CA glue
7) Wood grain lengthwise with piece unless noted
8) Dihedral = 1 in each wingtip
9) red = part pattern to cut, blue = reference marks
Notes:
front plate back piece(2 x 1/8 in)
Nose Plug, front view:
Side View:
(1/16 in)
prop1/32 wire hook
Bearing cutfrom Guillows"Sleek Streak"
Options:
Aluminum tubeGlass bead
Bearing fromPeck Polymers
drill block,glue bearing
(b)
(c)
Windshield pattern
Use thin plastic sheet, or paper
1/16 inshim: downthrust
shim