T HE E XPERIENCE OF T RANSITION TO IP V 6 Sudan University of Science & Technology.
-
Upload
zechariah-laughton -
Category
Documents
-
view
213 -
download
0
Transcript of T HE E XPERIENCE OF T RANSITION TO IP V 6 Sudan University of Science & Technology.
WHY A TRANSITION TO IPV6?
The IPv4 addresses are running out The Internet routing system is
getting overloaded IPv6 provides new features
Virtually unlimited addressing spaceThe size of an address in IPv6 is 128 bits, which is four times larger than an address in IPv4. A 32-bit address space allows for 232 or 4,294,967,296 possible addresses. A 128-bit address space allows for 2128 or 340,282,366,920,938,463,463,374,607,431,768,211,456 (3.4 × 1038) possible addresses.
Native support for mobility, security, multicast, etc.
Plug & play
KICK START IN SUDAN
National Telecom Corporation Initiative
Features of An Action Plan to Migration to IPv6
( 2011 – 2015)
And the Formation of the Sudanese IPv6 Taskforce ( SDv6 )
SUST Research and Development Center
Taking charge of testing the transition process ,then
created transition team
team has been started in 07/08/2010
IPV6 TEAM At the time of the second IPv6 workshop issued a decision of the
National Telecommunication Corporation, where is configured to migration to the IPv6 .It had been taken after the Director of Computer Center resolution create a team of members of the team on the formation of this shift, where he was Each of the following :
1. Dr. Mohammed Awad .2. Eng. Tariq Yassin.3. T. Mohammad Yagob Geiger(was the establishment of
the team).
IPV6 TEAM MEMBERS
1. Mohamed Yagob Geiger. (team leader).
2. Ayman Basheer Ahmed Alfaki.
3. Huzifa Abd-Alazim.
4. Mutaz Abd-Alhamed.
5. Mohammad Othman Ali Ayad.
6. Mohammad Hasab-Elrasol .
7. Namarig Suliman.
8. Rayan Yousif Abdo-Algadir.
STAGE ONE
ST6-Test lab After creating team and gather information about
new protocol, the team started to build a model (small IPv6 network), for testing and applying the new protocol on university's network.
Transition Mechanisms1. Dual-stack Mechanism.2. Tunnels Mechanism.3. Translation Mechanisms.
Depending on transition mechanisms the team divided into three team, each team apply and test one of mechanisms.
DUAL STACK TEAM
Dual Stack Mechanism
Most used migration approach nowadays.
A host with a dual stack can interoperate with both IPv4 and IPv6 nodes using IPv4 or IPv6 packets.
The IPv4 protocol stack will be used if the destination address used by the application is an IPv4 address.
The IPv6 protocol stack will be used if the destination address used by the application is an IPv6 address.
TUNNEL TEAM Tunnels Mechanism
tunneling Mechanism is consists of encapsulating IPv6 packets within IPv4, in effect using IPv4 as a link layer for IPv6.
Tunnels Types:1. 6in4.2. 6to4.3. ISATAP.4. Others.
Tunnel Broker A tunnel broker is a service which provides a network
tunnel.
These tunnels can provide encapsulated connectivity over existing infrastructure to a new infrastructure.
CONT …
6in4 and 6to4 are the Best types of this mechanism.
The team Found the Appropriate type of tunneling is Router to Router Tunnel.
TRANSLATION GROUP
Translation Mechanism The term “translators” refers to devices capable of
translating traffic from IPv4 to IPv6 or vice and versa.
This mechanism is intended to eliminate the need for dual-stack network operation by translating traffic from IPv4-only devices to operate within an IPv6 infrastructure.
We used the NAT-PT mechanism because it is the most available technique.
CONT …
Although there are many translation mechanism as we had seen but there are less compatible if we compared them with other transition techniques (dual-stack, tunneling).
We had simulated only the NAT-PT mechanism because it’s only embedded mechanism in CISCO router.
Also we would like to refer; in fact there is no need to use the translation technique. Because its only used when there are IPv6 only equipment or devices that connects to the network. But for truth there is no such a thing like that. All devices are either IPv4 only or IPv4/IPv6.
DHCPV6
Server
In ST6 Lab network we assigning address to hosts by using statefull autoconfiguration method, wide-dhcpv6-server under Ubuntu OS is intended to allow prefix delegation and host configuration for the IPv6 network protocol.
Client To configure client get address & information, we
using dhcpv6 client package for Linux and dibbler client for windows XP (windows 7 and vista support GUI configuration).
WEB & FTP
Web server The running web server in the SUST Lab is Apache
1.3.29, which is used to host the website of the SUST IPv6 homepage.
FTP server
IPv6 support is included in the official source of the Proftpd ,and it proven high-performance, scalable FTP server.
STAGE TWO Start the transition process in the
university (west campus). Enable IPv6 in hosts
Build IPv6 service Configure DHCPv6 Server
Check the connectivity between stations.
Configure HTTP Server
Configure DNS Server Client’s reach local domains using DNS.
Configure FTP Server Check FTP connectivity in the university (west campus)
network.
TUNNEL BROKER
Hurricane Electric Tunnel broker
Because we haven’t got a native IPv6 link delivered from (Sudatel-Canar-SUIN), We using transition mechanisms like configured tunnel to access IPv6 internet by registering in Hurricane Electric Tunnel broker.
PROBLEMS ISPs
Hardware Supporting
(as router and printers)
Software Supporting
(as Operating System: windows7 ,windowsXP ,pervious versions and Linux ).
Firewalls.
Work Environment .