Submerged ArcProduct and Procedure Selection

With disconnected LN-8 or LN-9 wire feeders, set the inch speed for the slow rate. If the arc flutters on and off, increase the inch speed. If inch speed is too fast, the wire will tend to stick on starting.

Position the gun over the joint as described under “Gun Operating Positions”. Allow the mound of flux to form. Press the trigger and touch the electrode to the work by lightly scratching through the flux.

If the electrode hits the work, pushing the gun up without starting the arc, immediately release the trigger, raise the gun, and turn the nozzle up. Be sure the work lead makes a good connection and the work is clean at the starting point. Clip the electrode end and try again.

K113

THE LINCOLN ELECTRIC COMPANY 22801 Saint Clair Avenue • Cleveland, OH • 44117 • U.S.A.

Phone: +1 216.481.8100 • www.lincolnelectric.comPublication C5.50 | Issue Date 08/14 © Lincoln Global Inc. All Rights Reserved