Present MFT planes layout
description
Transcript of Present MFT planes layout
Reduction of MFT detector planes inner diameter could produce ineterference with the bellows and the beampipe support during the installation phase
Present MFT planes layout
16.5mm
100mm
D=54mm
D=60mm
D=40mm
16.5mm (vertical movement toto be done in less the 40mm-space between two bellow)
Planes betweeen bellows54 mm diameter hole detector plane needs to clear 60mm Bellows diameter (and 60mm diameter BP Al section)
MFT vs ITS
to be compared with CDR radius
200, 220, 410, 430
Outer layers lay-out studiesOption 1
Layers overlap
Overlap azimuthLayer 4=2.25Layer5=2.33Layer6=2.38Layer7=2.31
to be compared with CDR radius
200, 220, 410, 430
Outer layers Geometrical lay-out studiesOption 2
Layers overlap
Overlap azimuthLayer 4=2,11Layer5=2,33Layer6=2,30Layer7=2,32
to be compared with CDR radius
200, 220, 410, 430
Outer layers Geometrical lay-out studiesOption 3
Layers overlap
Overlap azimuthLayer 4=2.19Layer 5=2.33Layer 6=2.31Layer 7=2.31
to be compared with CDR radius
200, 220, 410, 430
Outer layers Geometricallay-out studiesOption 4
Layers overlap
Overlap azimuthLayer 4=2.33Layer 5=2.15Layer 6=2.31Layer 7=2.31
to be compared with CDR radius
200, 220, 410, 430
Outer layers Geometricallay-out studiesOption 5
Layers overlap
Layer 6 & 7
Layer 4 & 5
Layer Nr
Ladder Module Chip x module
Chip x submod
N submod
7 46 92 49x2 7 76 46 92 49x2 7 75 24 48 28x2 7 44 24 48 28x2 7 4
SERVICES WAY OUTA-Side
13
CAGE
MFT
ITS LAYER 4,5,6,7
ITS LAYER 1,2,3
BEAM PIPE
NEW ITS INTEGRATIONSERVICE BARREL
DETECTOR BARREL
TPC OD= 1130mmCAGE OD= 1100mmMFT OD= 1030mmITS OUT BARREL OD= 920mm