GSM BASED HOME GSM BASED HOME AUTOMATIONAUTOMATION

BY

P.B.VINAY KUMAR (09W11A0439)

N.NIRANAJAN REDDY (09W11A0426)

K.RAM PRASAD (09W11A0432)

T.SRINIVAS (09W11A0436)

UNDER THE GUIDANCE OFMr . DASARI NAGARAJU

INTRODUCTION

  Here is a circuit that lets you operate your home appliances like lights and water pump from your office or any other remote place.

2

BLOCK DIAGRAM

3

POWER SUPPLY

4

MICRO CONTROLLER

5

PIN CONFIGURATION Pins 1-8 are Port 1 Pin 9 is RST. Pins 10-17 are Port 3 Pins 18 &19 – Crystal (XTAL) Pin 20 – GND Pins 21-28 are Port 2 Pins 32- 39 are port 0 Pin 29 – PSEN Pin 30 – ALE Pin 31 – VPP

6

DTMF

If we press 1 , then two frequencies of corresponding row and column adds .i.e., 697hz + 1209hz = 1906hz

7

3.5 MM EARPHONE JACK

One wire comes from the ground terminal of the jack that is connected to common ground of the complete circuit .The other wire can be attached to any one of two signal terminals.

Signal

Ground

8

DTMF DECODER

o The HT9170B/D tone decoders consist of three band pass filters and two digital decode circuits to convert a tone (DTMF) signal into digital code output.

o When input signals are recognized to be effective, Direct Voltage becomes high, and the correct tone code (DTMF) digit is transferred.

9

RELAY DRIVER ULN 2003

o ULN stands for Universal Logic Network

o ULN is mainly suited for interfacing between low-level circuits and multiple peripheral power loads

10

RELAY

A relay is an electrical switch that opens and closes under the control of another electrical circuit.

In the original form, the switch is operated by an electromagnet to open or close one or many sets of contacts.

11

KIT OVERVIEW

12

WORKING

13

ADVANTAGES Home automation using mobile phone

For elderly and disabled in order to maintain their independence and safety.

Home security

Low cost and reliable system

14

APPLICATIONS

When :You are in traffic jam on the high wayWhat : You set microwave in slow cooking mode.

• Central office

• Industry Automation

• Remote control

• Remote data entry

15

CONCLUSION

The project “GSM BASED HOME AUTOMATION” has been successfully designed and tested. Integrating features of all the hardware components used have developed.

Presence of every module has been reasoned out and placed carefully thus contributing to the best working of the unit.

16

FUTURE ASPECTS

This product is aimed toward average consumers who wish to control household appliances remotely from their cell phones provided that the appliances are electrically controllable

Right now we have designed the project for control of two devices but it can be designed for more number of devices .It can be further expanded with a voice interactive system facility. A feedback system can also be included which provides the state of a device(whether it is on/off) to the remote user.

17

ANY QUERIES ???

18

19