CCM_TOOLS
2
DD+DIS378.05E Controls, Connections, and Setup Proc edures DOCUMENT CONTROL NOTE: The controlled version of this document resides on MedNet. A ny printed copy of this document is uncontrolled. Edition 2, Revision 1 CR 85-X Type 5148/100 Chapter 1 / 7 06-2008 CR 75.0 Type 5146/105 (as of SN ≥ 6000) Ag fa Co mp any Con fi den ti al 2. 1 Checki ng Installatio n Site Prerequis ites Check that all site prerequisites shown in the Installation Planning-C hecklist (can be found at the end of Chapter 11, CR 85-X Service Manual) are fulfilled before visiting the site. 2. 2 Requir ed Servi ce Programs 2.2.1 CCM-Tool The CCM-Tool is needed to create and modify the configuration file (adc.cpf) for the CR 85-X and the other CR system components. The latest version of the CCM-Tool is installed by default on the NX processing station (Go to Start Agfa Service CCM Tools). If not yet done create and/or adapt the configuratio n file adc.cpf together with the application specialist. NOTE: When integrating the digitizer into an existing network, it is strongly recommended to create a CPF– file beforehand (see CR 85-X Service Manual, Chapter 11, Installation Planning, checklist). For detailed information on the configuration file, see: ADC Applica tion Manual - C hapter 11, DD+D IS181.03E. 2.2 .2 Error Message Progr am The "SHOW ERROR PROGRAM" with the "ERROR.MSG file" translates the CR 85-X error codes into clear text. The "SHOW ERROR PROGRAM" is a part of IMOS, the "ERROR.MSG file" is loaded in the digitizer.
-
Upload
arbjan-rusi -
Category
Documents
-
view
82 -
download
0
description
agfa
Transcript of CCM_TOOLS
-
DD+DIS378.05E Controls, Connections, and Setup Procedures
DOCUMENT CONTROL NOTE:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 2, Revision 1 CR 85-X Type 5148/100 Chapter 1 / 7 06-2008 CR 75.0 Type 5146/105 (as of SN 6000) Agfa Company Confidential
2.1 Checking Installation Site Prerequisites
Check that all site prerequisites shown in the Installation Planning-Checklist (can be found at the end of Chapter 11, CR 85-X Service Manual) are fulfilled before visiting the site.
2.2 Required Service Programs
2.2.1 CCM-Tool
The CCM-Tool is needed to create and modify the configuration file (adc.cpf) for the CR 85-X and the other CR system components. The latest version of the CCM-Tool is installed by default on the NX processing station (Go to Start Agfa Service CCM Tools). If not yet done create and/or adapt the configuration file adc.cpf together with the application specialist.
NOTE:
When integrating the digitizer into an existing network, it is strongly recommended to create a CPF file beforehand (see CR 85-X Service Manual, Chapter 11, Installation Planning, checklist). For detailed information on the configuration file, see: ADC Application Manual - Chapter 11, DD+DIS181.03E.
2.2.2 Error Message Program The "SHOW ERROR PROGRAM" with the "ERROR.MSG file" translates the CR 85-X error codes into clear text.
The "SHOW ERROR PROGRAM" is a part of IMOS, the "ERROR.MSG file" is loaded in the digitizer.
CR 85-X - Chapter 01 - Controls, Connections and Setup Procedures 2.1.pdf2 Prerequisites for Installation2.1 Checking Installation Site Prerequisites2.2 Required Service Programs2.2.1 CCM-Tool2.2.2 Error Message Program
