Belly Dancer - NatureScapes.Net · Belly Dancer This image demonstrates the proper fit of the Belly...

of 2 /2
Belly Dancer www.thinktankphoto.com This image demonstrates the proper fit of the Belly Dancer. Step 1: Belt should be unbuckled. Hold Belly Dancer in front of you, keeping the crossed shoulder straps near your body as shown above. Step 2: Place your arms inside the outer straps, while holding the crossed portion at the top, as shown above. Step 3: Bring crossed portion of shoulder straps over your head. Step 4: Allow shoulder straps to hang on shoulders. Step 5: Connect the belt buckle in the back. Step 6: Adjust belt to fit properly around your waist. Step 7: Adjust front harness straps to minimize any slack. Step 8: Adjust back harness straps to keep top of straps in desired location.

Embed Size (px)

Transcript of Belly Dancer - NatureScapes.Net · Belly Dancer This image demonstrates the proper fit of the Belly...

  • Belly Dancer

    � www.thinktankphoto.com

    This image demonstrates the proper fit of the Belly Dancer.

    Step 1: Belt should be unbuckled. Hold Belly Dancer in front of you, keeping the crossed shoulder straps near your body as shown above.

    Step 2: Place your arms inside the outer straps, while holding the crossed portion at the top, as shown above.

    Step 3: Bring crossed portion of shoulder straps over your head.

    Step 4: Allow shoulder straps to hang on shoulders.

    Step 5: Connect the belt buckle in the back.

    Step 6: Adjust belt to fit properly around your waist.

    Step 7: Adjust front harness straps to minimize any slack.

    Step 8: Adjust back harness straps to keep top of straps in desired location.

  • Belly Dancer may be used with Camera Support Straps shown above.

    Step 1: Attachment clip will securely snap onto the front of the Shoulder Harness.

    Supporting Camera on Front Straps of Belly Dancer:

    Modulus components can be attached to the Belly Dancer Belt as shown above.

    Rotate: To “Rotate” modular components around the belt, place the white plastic divider behind the belt before securing the connection.

    Attaching Modulus and Skin Components to Belly Dancer:

    Lock: To “Lock” modular components in position, insert the white plastic dividers into the outside rail of the belt.

    2 www.thinktankphoto.com

    When using the Camera Support Straps, please note: If sufficient weight is not applied to the back of the belt, or if the belt is not tight enough, the front of the harness may pull backward due to lack of counter weight for your camera.