Wincor CCDM Training - TestLink Training TL1025v2.pdf · Wincor CCDM Training Course Number TL1025...
2
Wincor CCDM Training Course Number TL1025 How long does it last? 3 days How many students are there per course? The course is set to a maximum of 4 people to enable the optimum instructor to student ratio. What is it about? Instructor-led training based around the Wincor Cash and Cheque Deposit Module. Who is it aimed at? ATM field technicians, support engineers, ATM trainers, help desk support staff, rework centre technicians. What should you know before attending? 1 year's experience on Wincor XE ATMs. What will you achieve? If successful, after the course the student will be able to: • Diagnose CCDM faults down to module level • Replace any part or module • Carry out recommended adjustments • Carry out recommended preventative maintenance Which models are covered? CCDM V2 and V3 Which modules are covered? Dispenser module, Separator, Intermediate Transport, Alignment Module, MICR Module, Bill Validator (BEB), Control PCBs, ESCROW, Chassis, Caseete Module.
Transcript of Wincor CCDM Training - TestLink Training TL1025v2.pdf · Wincor CCDM Training Course Number TL1025...
Wincor CCDM Training
Course Number TL1025
How long does it last? 3 days
How many students are there per course?
The course is set to a maximum of 4 people to enable the optimum instructor to student ratio.
What is it about? Instructor-led training based around the Wincor Cash and Cheque Deposit Module.
Who is it aimed at? ATM field technicians, support engineers, ATM trainers, help desk support staff, rework centre technicians.
What should you know before attending? 1 year's experience on Wincor XE ATMs.
What will you achieve?
If successful, after the course the student will be able to:
• Diagnose CCDM faults down to module level
• Replace any part or module • Carry out recommended
adjustments • Carry out recommended
preventative maintenance
Which models are covered? CCDM V2 and V3
Which modules are covered?
Dispenser module, Separator, Intermediate Transport, Alignment Module, MICR Module, Bill Validator (BEB), Control PCBs, ESCROW, Chassis, Caseete Module.
What about software? K Diags can be used to test the module but is not always available for use in the field.
How do you measure effectiveness?
A successful strip down and reassembly of a working CCDM.
Where and when? If held at our Poole facility the course runs from 09:00 to 16:30 daily.
Lunch will be provided.
Can you train at my site? Yes, we can train anywhere subject to the instructor checking the ATMs and equipment prior to the start of the course.
Any more questions? Please contact [email protected] or +44 (0)1202 621100.
We look forward to seeing you.
