WEB Broadcast Power Monitor - Clarke & Severn Electronics · WEB Broadcast Power Monitor Type 3024...

2
WEB Broadcast Power Monitor Type 3024 The COMM-connect 3024 Broadcast Power Mo- nitor can control up to 8 external RF Measuring heads. The high dynamic range with external couplers and RF measuring heads cover from 1W to 1MW. The Power conversion algorithms handles multi carrier, multi mode, peak, average and RMS signals. The power readout is auto scaled and VSWR can be calculated between any probes. Also the measured and calculated results along with alarms can be shown in the local LCD. The instrument has SNMP support to allow network management. The instrument can be configured for VSWR and Power limits to gi- ve alarms. The alarms can be configured to ope- rate relay drivers or isolated Optocouplers. The alarms can also be configured as SNMP traps sending relevant information to the network con- trol center or sending an e-mail. All values are logged and time stamped to a USB stick every minute. The COMM-connect 3024 WEB enabled Power Monitor gives an unlimited number of ap- plication to monitor and control the last part of your RF network installation from transmitters to the antenna. Applications / Features: Site control Fast access to site data Cost effective site management Full network control Web management tool Data logging Early warning on Combiner, Cable or Antenna failure SNMP Rev. 1, 09/2013 Page 1 of 2 COMM-connect A/S reserves the right to change prices and specificaons without prior noce

Transcript of WEB Broadcast Power Monitor - Clarke & Severn Electronics · WEB Broadcast Power Monitor Type 3024...

Page 1: WEB Broadcast Power Monitor - Clarke & Severn Electronics · WEB Broadcast Power Monitor Type 3024 ... be configured for VSWR and Power limits to gi-ve alarms. The alarms can be configured

WEB Broadcast Power Monitor Type 3024

The COMM-connect 3024 Broadcast Power Mo-

nitor can control up to 8 external RF Measuring

heads. The high dynamic range with external

couplers and RF measuring heads cover from

1W to 1MW. The Power conversion algorithms

handles multi carrier, multi mode, peak, average

and RMS signals. The power readout is auto

scaled and VSWR can be calculated between

any probes. Also the measured and calculated

results along with alarms can be shown in the

local LCD. The instrument has SNMP support to

allow network management. The instrument can

be configured for VSWR and Power limits to gi-

ve alarms. The alarms can be configured to ope-

rate relay drivers or isolated Optocouplers. The

alarms can also be configured as SNMP traps

sending relevant information to the network con-

trol center or sending an e-mail. All values are

logged and time stamped to a USB stick every

minute. The COMM-connect 3024 WEB enabled

Power Monitor gives an unlimited number of ap-

plication to monitor and control the last part of

your RF network installation from transmitters to

the antenna.

Applications / Features:

• Site control

• Fast access to site data

• Cost effective site management

• Full network control

• Web management tool

• Data logging

• Early warning on Combiner, Cable or Antenna failure

• SNMP

Rev. 1, 09/2013 Page 1 of 2

COMM-connect A/S reserves the right to change prices and specifica�ons without prior no�ce

Page 2: WEB Broadcast Power Monitor - Clarke & Severn Electronics · WEB Broadcast Power Monitor Type 3024 ... be configured for VSWR and Power limits to gi-ve alarms. The alarms can be configured

Manufacturer:

COMM-connect A/S Sigerslevoestervej 11 DK-3600 Frederikssund Phone: +45 48 28 82 82 Email: [email protected] Web: www.comm-connect.com

Distributor:

Rev. 1, 09/2013

Specifications:

• Frequency range: 10MHz til 2500MHz

• VSWR range: 1:1 - 9:1

• Power range: 1 W to 10 MW

• Max. probes: 8

• Power meas. modes: RMS, Peak sync, Frame Average

• Ethernet: Fixed IP address or DHCP

• Protocol: TCP, UDP, HTTP, FTP

• Reporting: SNMP, E-mail

• Configuration: Web Manager tool

• RS232 i/f speed: 9600BpS

• Data logging: USB or SNMP

• Digital output type: Open collector

• Digital input type: TTL 5 V

• Enclosure: 19” 1U

• Power supply: 100 V to 240 V AC

• Temperature range: 0° C to 50° C

Functions:

• Measure Forward and Reflected Power

• Measure correct RMS Power

• Calculate VSWR

• 1-line display (rotating values)

• Display Power and VSWR

• WEB display:

- Power

- VSWR

- Alarms

• SNMP with traps

• Cost effective

• High accuracy

• Digital out

• Opto out

• RS-232

• Ethernet

• Web manager tool

• Analog out (Moving coil meter)

Page 2 of 2

COMM-connect A/S reserves the right to change prices and specifica�ons without prior no�ce

WEB Broadcast Power Monitor Type 3024