We Care for you and your Patients...ICU for bedside procedures Surgical Masks ASTM Level 3 OR Sta˚...
Transcript of We Care for you and your Patients...ICU for bedside procedures Surgical Masks ASTM Level 3 OR Sta˚...
Personal Protective Equipment
We Care for you and your PatientsAt VEN Medical, Our customers are in our mind in whatever we do.
Facial Masks Isolation Gowns Coveralls Haircover Shoe Cover Gloves
Choose the right maskThe right mask is an ASTM-rated mask.
Follow the leaders
ASTM International sets the preferred international standard in healthcare for best practices inclusive of testing and requirements
for performance of materials. The FDA, who oversees the sale and marketing of all surgical masks, recommends that manufacturers
demonstrate mask performance in 4 areas:
Protection over preferenceSafety is everyone’s concern but your mask choice is your own. With all of the key facts and safety factors in mind for you can
select an ASTM-rated mask that is right for you and protects the best.
Fluid resistanceIn matters of splatter
When at risk of encountering blood and/or bodily fluid splatter, wear the recommended ASTM Level 3 fluid-resistant mask and get
the best protection for the OR.
Fit The fit is it
even the right mask not worn correctly could put you at risk. Nose and mouth must be coverd completely. Create a seal around the face to
prevent gaps that increase the risk of inhalation exposure
The “4 Fs” of selecting the right mask*Use ASTM standards to support choices around Filtrations and Fluid Resistance
Bells and whistles, Ties and loopsSecurement - loops or ties
Anit-fog film, form and tapesreduce distractions from fogging issues shields
and protective eyeware keep eyes clear ofblood and splash
FeaturesFiltrationFilter it
When your’re around smoke or are interacting with aTB-infected patient, properly protect yourself with a high
filtration mask (N95 Respirator)
1
2
3
ASTM F2100-11 Levels Char
acte
rist
ics
Resi
stan
ce to
pen
etra
tion
by
synt
hetic
blo
od, m
inim
um
pres
sure
in m
m H
g fo
r pas
s res
ult
m
m H
20/c
m2
(Bre
atha
bilit
y)
Bact
eria
l
Sub-
mic
ron
part
icul
ates
Flam
e sp
read
Level 1: low barrier protection General use for short procedures and exams 80 mm Hg <4.0 ≥95% ≥95% Class1
Level 2: moderate barrier protection For low to moderate levels of aerosols, 120 mm Hg <5.0 ≥98% ≥98% Class1
Level 3: maximum barrier protection 160 mm Hg <5.0 ≥98% ≥98% Class1
Understanding ASTM levels of protection is key
*
†
§
“General” or “Basic” implies abdominal
Common procedures where Cardinal Health Clinician’s recommend an ASTM LEVEL 3 MASK
Procedure MasksASTM Level 1
Patient & Sta� isolation:Clean environments, sterile cores,processing departments, ER andICU for bedside procedures
Surgical MasksASTM Level 3
OR Sta� in sterile environments:Closeness of �t protects against�uid transmission or - intended fora high-risk of �uid exposure
N95 RespiratorNIOSH N95
Protection againts residual surgicalsmoke or on patients wuth known or suspected aerosol transmitted diseases-- Tuberculosis | Varicella | Rubeola 2
Level UpThe di�erence in protection between a Level 2 mask and a Level 3 mask is minimal.
When it is solely a matter of micromillimeters, level up your mask selection and get the best protection with an ASTM Level 3 mask.
The risk of exposure to blood and bodily �uid splat-ter in the OR is signi�cant and the protection o�ered in an ASTM Level 1 mask is minimal. (Twicw the protection in aL3/L1)
When the risk is unknown or too great to ignore, Level up your mask selection and get the best pro
**
AAMI PB70 guidelines
ANSI/AAMI PB70 Barrier performance
Test method Requirement Anticipated
AAMI Level 1 Water resistance: Impact penetration AATCC 42
AATCC 42 Measures the resistance of fabrics to the liquid penetration of water by impact
Water impact < 4.5 g Minimal
AAMI Level 2 Water resistance: Impact penetration AATCC 42
Water resistance:Hydrostatic pressureAATCC 27
AATCC 42 Measures the resistance of fabrics to the liquid penetration of water by impact
AATCC 127 Measures the resistance of fabrics to the liquid penetration of water by impact under constant and increasing hydrostatic pressure
Spray impact < 1.0 g
Hydrostatic Pressure > 20 cm
AAMI Level 3 Water resistance: Impact penetration AATCC 42
Water resistance:Hydrostatic pressureAATCC 27
AATCC 42 Measures the resistance of fabrics to the liquid penetration of water by impact
AATCC 127 Measures the resistance of fabrics to the liquid penetration of water by impact under constant and increasing hydrostatic pressure
Spray impact < 1.0 g
Hydrostatic pressure > 50 cm
Moderate
AAMI Level 4 ASTM F1671, Standard Test Method for Resistance of Materials Used in Protective Clothing to Penetration by Blood-Borne Pathogens Using Phi-X174 Bacteriophage Penetration as a Test System
ASTM F1671 Measures the resistance of materials used in protective clothing to penetration by blood borne pathogens using a surrogate microbe under conditions of continuous liquid contact.
Pass
Association for the Advancement of Medical Instrumentation.Protective Apparel and Drapes Intended for use in Health Care Facilities. ANSI/AAMI PB70:2012. Arlington, VA: AAMI.
Choose the Right Surgical Gown
Infection Control GuideSafety starts well before themoments a clinician entersthe patient’s room. Use thesetting usage key and materialdescriptions as a guide to select gowns and other apparel, soyou can provide the rightoptions for every situation.
AAMI Level guideWe’re your source for AAMI compliant gowns. Choose thelevel you need, based on the green/ orange/ blue/ purple color coding in the following chart
Get In TouchWe Love to Hear From You
62, 9th Cross, Thirumangal Nagar,Peelamedu, Coimbatore - 641004.
+91 9384606891
VEN Medical India Private Limited