TM iGAZER32P Polarized Photo Eyes - Transmitter Solutions
Transcript of TM iGAZER32P Polarized Photo Eyes - Transmitter Solutions
Features:
iGAZER32P Polarized Photo Eyes
“Polarized” / Twin Finish Housing
"Polarized Sensor "- total safety sensorRetro-reflective typeRed infrared led elementNEMA 4X(IP-66) water proof/cable glandPMMA upper casing, anti fog/dew/rainsRound shape reflector-Dia.: 3¼ inchesInput volt.: 12- 250 VAC/DCTwin colors LED indicator for beam alignment Tamper switches included
Gate openerOverhead doorSwing gateSliding doorPerimeter protectionWindowTerraceWarehouseParking lot
Dimensions:
Specifications:
Application:
Input Volt.Tx Led Elem entBeam Spreading angle Contact CapacityResponse TimeDelay Time of Relay
Sens ing Range
Led Indicators
Addi tiona l FunctionWiring Connection Housing Material IP Environment/Storage Temp.Dimension
AC/DC 12 - 250V (Non Polarit y)
Red infrared/Wave length 740 nm 1.5 (half angle)
0.5A/120VAC (1A/30 VDC)10 msec
100 msec
33 ft
Tamper switchesTerminal block / Cable gland NEMA 4X(IP-66)Bottom casing: AB S / Upper casing: P MMA
NEMA 4X(IP-66)-13˚F to 140˚F / -31˚F to 176˚F
Red led Off: Beam aligned / Red led On: Beam brokenRed led flah: Beam alignment signal weak (Re-align )Green led on: Beam aligned proper
.63 .3
.3
.2
.55 .524.8”
2”
2.4” 2.4”
1.9”
UNIT: inches
TM
4 (L) 2¼ (W) 2¼ (D) inches 4 5
Solar Drain Standby (Beam aligned) ±10%: 44mA / Trigger ±10%: 20mA
Parts Account:
Wiring Connection:
Hood for SensorMounting Bracket
Rubber Ring
Upper Casing Terminals
Cable Gland
Lens
Horizontaladjustment
Tamper Switch
Vertical adjustment screw
1 2 3 4 5 6 7
AC/DC 12~250V
N C
N C
NO COM TP1 T P2
A C/D C Non po lar ity
PWR/Beam AlignmentLED Indicator
1 2 3 4 5 6 7
AC/DC 12~250V
NC
NC
NO COM
TP1
TP2
AC/DC Non polarity
1 2 3 4 5 6 7
AC/DC 12~250V
NC
NC
NO COM
TP1
TP2
AC/DC Non polarity
Additional function:TP 1/TP 2 - Tamper Switches, can be connected with controlpanel or siren as burglar alarm.
The guarantee period of this product is 24 months, beginning from the manufacturer date. During this period, if the product does not work correctly, due to a defective component, the product will be repaired or replaced at the discretion of the producer. The guarantee does not cover the plastic enclosure integrity. After- sale service is supplied at the producer's factory.
WARRANTY