UZIN | A Brand of Uzin Utz AG

Dieselstrasse 3 | D-89079 Ulm | Telephone +49 (0)731 4097-0 | Telefax +49 (0)731 4097-110| E-mail info@uzin.com | Internet www.uzin.com

SUSTAINABILITY-DATASHEET

UZIN KE 2000 S

Universal pressure-sensitive and wet adhesive

Identification of hazards: The product does not require labelling according to directive 1999/45/EC respectively regulation (EC) No 1272/2008

Indoor air quality (VOC)

EMICODE EC 1 PLUS – very low emission

Blue Angel according to RAL-UZ 113 – special environmental friendliness

Life Cycle Assessment (LCA)

LCA according to ISO 14040/44 � EPD according to EN 15804; third party verified

Functional Unit (FU): 1 kg product; cradle-to-gate (according to EN 15804: Modules A1-A3)

Global warming potential (GWP 100) [kg CO2-Eq./kg] 0,66 Total use of non renewable primary energy resources

[MJ/kg] 30,12

Depletion potential of the stratospheric ozone layer (ODP)

[kg R11-Eq./kg] 7,84E-08 Total use of renewable primary energy resources

[MJ/kg] 6,05

Acidification potential of land and water (AP)

[kg SO2-Eq./kg] 3,25E-03 Waste categories:

Eutrophication potential (EP) [kg PO4-Eq./kg] 1,49E-03 Hazardous waste disposed [kg/kg] 9,41E-07

Formation potential of tropospheric ozone photochemical oxidants (POCP)

[kg ethene-Eq./kg]

6,11E-04 Non hazardous waste disposed [kg/kg] 4,15E-01

Abiotic depletion potential for non fossil resources (ADPe)

[kg Sb-Eq./kg] 3,12E-06 Radioactive waste disposed [kg/kg] 1,02E-04

Abiotic depletion potential for fossil resources (ADPf)

[MJ/kg] 27,97 Use of net fresh water [m3/kg] 0,37

Resources:

Natural, mineral resources 20-30 % Secondary materials / recycling materials 0 %

Renewable materials 0 % Water content 20-30 %

Average origin of materials 1076 km Packaging: plastic bucket

Certification of Green Buildings

LEED (Compliance test IEQ 4.1)

VOC Emission test according to SCAQMD Rule 1168 is met externally verified

Additional test CA 01350 (California Specification Section 01350) is met externally verified

BREEAM

Product neither contains carcinogenic nor sensitising volatile substances

Test-chamber measurement performed according to EN ISO 16000-9. Isocyanates or other sensitising volatile substances have not been detected in the test-chamber measurement.

Substances prohibited in BREEAM requirements for Flooring adhesives – Hea 9 - Volatile Organic Compounds are neither used nor will be emitted from this product.

DGNB (Profile 6: Risks for the local environment)

VOC-content (acc. to 2004/42/EG); Product meets quality level 4

EMICODE EC 1 PLUS or RAL-UZ 113

Certifications: Safety Data Sheet, license of EMICODE EC1 PLUS, certificate of the German Blue Angel and other product related information are

available for download under www.uzin.com

Use of US Green Building Council Member logo does not imply that USGBC has approved this confirmation or any mentioned product. Use of this logo just states that Eurofins Product Testing A/S is member of US Green Building Council.

Eurofins Product Testing A/S Smedeskovvej 38 DK 8464 Galten / Denmark

Tel +45 70 22 42 76 Fax +45 70 22 42 75

www.product-testing.eurofins.com

CCoonnffiirrmmaattiioonn Eurofins Product Testing A/S confirms that a sample of an adhesive with the name:

UUZZIINN KKEE 22000000 SS supplied by

UUzziinn UUttzz AAGG showed low VOC emissions in a test in accordance with: California Department of Health Services Standard Practice for The Testing Of Volatile Organic Emissions From Various Sources Using Small-Scale Environmental Chambers, including 2004 Addenda (California Specification Section 01350), as specified in LEED for Schools Credit 4.1 (Adhesives and Sealants). Emissions were below all limit values as specified in the standard. Testing was performed in March 2012 (test report no. G13830). The testing methodology is covered by independent ISO 17025 accreditation, issued by DANAK (# 168). With this confirmation, use of product UZIN KE 2000 S will qualify for fulfillment of LEED for Schools Credit IEQ 4 (Adhesives and Sealants).

30 April 2012

_____________________ _____________________ Thomas Neuhaus Dr. Arja Valtanen Head of Product Emission Test Center Analytical Service Manager

This product meets with the guidelines for the criteria of use listed reverse. The company is ordinary member of the GEV.

OM 010 June 29, 2016 valid until June 29, 2021

Licence Number: 3197/24.02.97

For the product UZIN KE 2000 S

Of company Uzin Utz AG

Due to application date July 12, 2011 With reference to the classification in accordance with the directives as stipulated in § 10 of the GEV trademark constitution on behalf of the GEV for the above mentioned product as per § 5, section 4 of the GEV trademark constitution is awarded the licence for the use of the GEV trademark

Requirement guidelines for the awarding of the EMICODE licence

The flooring installation material mentioned in the front side licence has to meet with the following criteria in accordance with the constitution and guidelines of the Technical Advisory Board of the GEV and others:

• The product meets all the legal requirements, especially the chemical law and its specifications.

• The product is solvent free due to occupational health. Only in case of a wood flooring coating it might contain low content of solvents.

• A safety data sheet (MSDS) according to local law in its respectively valid version is to be established for the product.

• Carcinogenic, mutagenic, reprotoxic substances as well as those substances under suspicion to cause such defects are not permitted to be used in the manufacturing of this product.

• The testing of the product is in accordance with the defined GEV test method. Afterwards the definition of VOC is conducted in a test chamber by using the Tenax thermodesorption procedures with GC/MS analysis.

• The classification into the EMICODE classes is performed according to the following listed and described criteria and TVOC concentration groups. For product labelling the matching EMICODE class is to be used.

GEV product matrix

EMICODE

EC 1PLUS

EC 1 EC 2

TVOC/TSVOC28d in µg/m³

1. Liquid products

After 3 days

< 750 TVOC;

after 28 days

< 60 TVOC /

< 40 TSVOC

After 3 days

< 1000 TVOC;

after 28 days

< 100 TVOC /

< 50 TSVOC

After 3 days

< 3000 TVOC;

after 28 days

< 300 TVOC /

< 100 TSVOC

1.1 Primers (floor and wall)

1.2 Ready to use thin fixations and adhesives

1.3 Damp proof primers or barrier primers

1.4 Liquid sealants, pasty surface sealants

2. Mineral products

2.1 Cement and calcium sulphate based levelling compounds

2.2 Cement based and other mineral tile mortars and joint fillers

2.3 Waterproofing slurries

2.4 Screeds and screed binding materials

3. Pasty products with high content of organic binder

3.1 Pasty adhesives for floor coverings and parquet, ready-to-use adhesive for ceramic tiles, other adhesives

3.2 Pasty fixations for floor coverings

3.3 Levelling compounds (based on dispersion or reactive resin)

3.4 Powder based adhesives with high content of organic binder

4. Ready to use products which do not require chemical curing or physical drying

4.1 Underlays

4.2 Insulating underlays

4.3 Self-adhesive tapes and underlays

4.4 Installation boards, decoupling/insulation boards, wall panels

5. Joint sealants, joint insulations, joint sealing tapes

5.1 Joint sealants (based on dispersion or reactive resins), repair fillers

5.2 Joint insulations, expanding foams

5.3 Pre-compressed or foam plastic joint sealing tapes

5.4 Sealing membranes, tapes, sleeves for small surfaces

5.5 Sealing membranes for large surfaces

6. Surface coating for wood floorings < 100 Σ TVVOC,

TVOC, TSVOC

thereof max. 40 SVOC

< 150 Σ TVVOC,

TVOC, TSVOC

thereof max. 50 SVOC

< 450 Σ TVVOC,

TVOC, TSVOC

thereof max. 100 SVOC

6.1 Waterborne wood floor coatings

6.2 Water-based joint filler for parquet

After 3 days < 750 TVOC; after 28 days < 60 TVOC /

< 40 TSVOC

After 3 days < 1000 TVOC; after 28 days < 100 TVOC /

< 50 TSVOC

After 3 days < 3000 TVOC; after 28 days < 300 TVOC /

< 100 TSVOC

Edition: April 3, 2014 * TVOC = Total Volatile Organic Compounds

Trade name(s):

valid until:118096 31.12.2016

2016

Signed:

Date: 10.10.2016

Name: Dr. Michael Zieger

Position: Head of Product Safety and Compliance

EUROPEAN COMMUNITIES DECLARATION OF CONFORMITY

issued in accordance with the

MARINE EQUIPMENT DIRECTIVE (MED) 2014/90/EU

Module B: EC Type Examination Certificate:

MED Annex A.1 Item No & Item designation:

This is to certify that in compliance with the Council Directive 2014/90/EU of 23 July 2014 on marine equipment, last amended by Commission Directive 2015/559/EU, the company:

Dieselstrasse 3

declares that the following product(s) is/are conforming to types as described in the EC-Type Examination Certificates from the Notified Body BG Verkehr (Ship Safety Division) (EC Registration No. 0736).

UZIN Utz AG

D-89079 Ulm - Germany

Module D, Quality Certificate No. SEE 15088 valid until 27.10.2018

UZIN Utz AG

D-89079 Ulm - GermanyDieselstrasse 3

Annex 1, Part 5Standards applicable: IMO Res. MSC.61(67)-(FTP Code)

A Technical Construction File for this equipment is retained at the following address:

UZIN KE 2000 S

A.1/3.18e - Surface materials and floor coverings with low flame-spread characteristics (adhesives used in the construction of "B" & "C" class divisions)

The mark of conformity is affixed to the label of the packed material(s) including the Identification Number of the Notified Body:

0736

Declaration of Conformity 1 / 1