“STTP on UTM, CNC and Machining Processes” organized by on STTP.… · “STTP on UTM, CNC and...
Transcript of “STTP on UTM, CNC and Machining Processes” organized by on STTP.… · “STTP on UTM, CNC and...
“STTP on UTM, CNC and Machining Processes” organized by
Department of Mechanical Engineering, GIMT Guwahati
Department of Mechanical Engineering, GIMT Guwahati organized a five day short term
training programme on “UTM, CNC and Machining Processes” from 12th to 16th December
2016 for lab instructors and technicians. The programme covered the theoretical knowledge
on UTM, CNC and machining and also gave them a hands-on experience by providing a
practical exposure of UTM, CNC lathe, conventional lathe, milling machine etc. The experts
for the programme were Mr. Nandan Kanan Das, Assistant Workshop Superintendent, IIT
Guwahati who delivered lectures and conducted practical sessions on UTM and Machining
Processes and Mr. Prabin Kumar Bora, Technical Officer, Dept. of Mechanical Engineering,
Tezpur University, who delivered lectures and conducted practical sessions on CNC. There
was no registration fee for the participants. A total of 35 (Thirty five) participants registered
for the programme of which almost 50% participants were from institutes like PCPS Girls’
Polytechnic Guwahati, Assam Don Bosco University, NITS Mirza, Royal School of
Engineering and Technology, RIST Meghalaya, Scholars’ Institute of Technology and
Management and the rest were from GIMT Guwahati.
The programme began with an inauguration ceremony on 12th December 2016 which was
attended by Prof. S. K. Dutta, Principal, GIMT Guwahati, Mr. N. K. Das Assistant Workshop
Superintendent, IIT Guwahati, Mr. M. R. Singha, Dean (Academic), GIMT Guwahati, Capt.
(Retd.) Navy I. P. Sharma, Dean (Administration), GIMT Guwahati, Prof P. K. Dutta, Senior
Professor, Dept. of Mechanical Engineering, GIMT Guwahati, Dr. B. J. Bora, HoD (i/c),
Dept. of Mechanical Engineering, GIMT Guwahati and many other faculty members of
GIMT Guwahati. The expert for the day was Mr. N. K. Das who conducted a visit to the lab
in the first half of the programme and conducted a theory session on UTM in the second half.
Mr. Das conducted another theoretical as well as a practical session on UTM the following
day i.e. 13th December 2016. On 14th December 2016, Mr. Das conducted a theoretical
session on machining processes in the first half and went for a practical session in the second
half. Mr. P. K. Bora conducted theory and practical sessions on CNC on 15th and 16th
December 2016. The programme ended with a valedictory session on 16th December 2016
which, along with the dignitaries of the inaugural session, was also attended by Mr. R. Das,
President, SSA Society and Mr. A. Chowdhury, Member, SSA Society. The participants
received their certificates in the ceremony and the organizing committee collected the
feedback of the participants on the programme.
LIST OF RESOURCE PERSONS
1. Mr. Nandan Kanan Das
Assistant Workshop Superintendent
IIT Guwahati
2. Mr. Prabin Kumar Bora
Technical Officer
Department of Mechanical Engineering
Tezpur University
Photographs of the STTP