Static charges on center-cum-surface rewinder
-
Upload
ate-private-limited -
Category
Business
-
view
21 -
download
0
Transcript of Static charges on center-cum-surface rewinder
VALENCE ELECTRONS PRIVATE LIMITED 32 K R Colony, Domlur Layout, Bangalore 560 071, India T: +91-80-4125 6570 E: [email protected] W: www.ategroup.com/valence Registered Office: 43 Dr V B Gandhi Marg, Fort, Mumbai 400 023, India CIN: U74999MH2000PTC127595
Application note
Published date: 31-12-2016 | Rev: 1A
Page 1
Static charges on center-cum-surface rewinder Problem
In a center-cum-surface rewinder, static charge levels can be extremely high. Depending on the substrate
being processed and the ambient conditions, surface voltages have been observed to be more than ±100 kV.
The other challenge is in locating the static charge eliminator for effective removal of the static charges of the
web on the rewinder.
Solution
Valstat® VR 80 DC long range static eliminating bars are ideally suited for this application. These bars can
be installed in a location that does not hamper web handling, as shown in diagram above. Static charges are brought down to near zero levels, even if the static eliminating bar is 400 mm away from the target.