SMS Setup Manual

216, Regal Trade Square Voice/Fax: 021-6022692 Cell #: 03009252461 E-mail: [email protected]

Contents Page no.1. Hardware Requirements 2. Software Requirements 3. Installation of Modem 4. Installation SMS Sending Application 5. How to use 6. Data Backup

22

2…..45…...14

14……1617


SMS Setup Configuration Hardware Requirements P-IV Class Machine with at least 512MB of Memory and about 20 GB of Hard disk Drive with at least 2 17” Monitor GPRS Modem (USB) Mobile SIM (Any adequate service Provider)

Software Requirements Windows XP Operating System with SP-2 MS-Office Modem Driver Installed Properly Back End SMS gateway Application (for sending SMS) Front End SMS Composing Application

Installation of Modem Insert Modem into USB port Locate driver when prompt (it is located in CD which has been provided to you) Install Modem according to procedure. Now right click on My Computer>Manage>Device Manager on left column. At device manager on left column you will find modems>USB GPRS Modem As shown in fig.


Right click on USB GPRS Modem then Properties

Note down Port no. you will need it later

Click on diagnostics then Query Modem

If following screen appears it means you have successfully installed and configured modem


If it does not appear then try again or Contact Support @ 03009252461, Muhammad Imran


Go through Installation of SMS sending application Installation of Application In CD-ROM Locate file mmessenger(MobleMessenger).exe Run Setup by Double Clicking Application

Click on “Yes”

Click on “Start”


Click on “Yes”

Click on “OK”


Click on Change directory

Select Drive “D:” from Drive menu


Then type Manually folder name where you want to install application (for example “SMS”) then Click on “OK”

Click “Yes”


Click here to begin Installation

Click “Continue”


Click “Yes”

Click “Yes”


Click “Yes”

Click Yes


Click Yes

Click OK You have successfully installed application Go to start>All programs> find “mobile messenger”


Find “mobile messenger> Mobile Messenger

Click on register


Click registration Information

Type following Name=muhammadimran Registration code=314300225 Click OK Close Application and Restart, now you will not ask for registration


How to Use ?

Go to File>Settings

Select Comport of Your GPRS Modem which was noted down before, then click OK


Now

Check this box, and type number according to format below

Number format : +92aaabbbbbbb Where a=Operator Code with out “0”(300,333,321,345, etc.) B=Recipients Number Type Message and click Send


Back of Data Base Click On my Computer then Select Drive “D:” .In Drive D: locate folder name “SMS”

In folder SMS, Copy Both These files to some other location periodically. These are main data base files In case of re-installation of Application replace them with original.

For any further Detail Please consult Help or Call 03009252461 Monday to Saturday 10:00AM to 8:00 PM

SMS Setup Manual

Documents

Transcript of SMS Setup Manual