S ter emtr Tribology laboratory services - SINTEF · Tribology laboratory services September 2013...
1
Technology for a better society FACTS SINTEF Materials and Chemistry www.sintef.com September 2013 Tribology laboratory services Our mission Tribology is the muldisciplinary science on wear, fricon and lubricaon of interacng surfaces in relave moon. Research in tribology is oſten highly dependent on the final applicaon. The mission of the Tribology Lab at SINTEF/NTNU is to adapt our knowledge and equipment to our clients’ needs. Standard testing ■ ASTM G65: Measuring abrasion using the dry sand/ rubber wheel apparatus. ■ ASTM G73: Liquid impingement erosion test. ■ ASTM G77: Sliding wear using block on ring wear test. ■ ASTM G99: Wear tesng with a pin-on-disk apparatus. ■ ASTM G105: Wet sand/rubber wheel abrasion test. ■ ASTM D4060: Abrasion resistance of organic coangs by the Taber Abraser. General view of the Tribology Lab Modified tribometer for in situ measurements. Contact: Sergio Armada, Research Scienst E-mail: [email protected] Phone: +47 93 09 54 12 SINTEF Materials and Chemistry box 4760 Sluppen, NO-7465 Trondheim, Norway Phone: + 47 40 00 37 30 hp://www.sintef.no/mc Customized testing Standard tests do not always sasfy our clients’ needs. The Tribology Lab connuously works on offering new test equipment able to simulate the final applicaon more realiscally. Some examples include: Tribocorrosion tests: ■ Corrosion and wear in riser tensioner piston rods in offshore applicaons. In situ tribology: ■ Analysis of contact area between sapphire and any counterpart by interferometry. Photo: Thor Noelsen
Transcript of S ter emtr Tribology laboratory services - SINTEF · Tribology laboratory services September 2013...
Technology for a better society
FACTS
SINTEF Materials and Chemistry
www.sintef.com
September 2013Tribology laboratory services
Our missionTribology is the multidisciplinary science on wear, friction and lubrication of interacting surfaces in relative motion. Research in tribology is often highly dependent on the final application. The mission of the Tribology Lab at SINTEF/NTNU is to adapt our knowledge and equipment to our clients’ needs.
Standard testing■ ASTM G65: Measuring abrasion using the dry sand/
rubber wheel apparatus.
■ ASTM G73: Liquid impingement erosion test.
■ ASTM G77: Sliding wear using block on ring wear test.
■ ASTM G99: Wear testing with a pin-on-disk apparatus.
■ ASTM G105: Wet sand/rubber wheel abrasion test.
■ ASTM D4060: Abrasion resistance of organic coatings by the Taber Abraser.
General view of the Tribology Lab
Modified tribometer for in situ measurements.
Contact:Sergio Armada, Research ScientistE-mail: [email protected]: +47 93 09 54 12
SINTEF Materials and Chemistrybox 4760 Sluppen, NO-7465 Trondheim, NorwayPhone: + 47 40 00 37 30http://www.sintef.no/mc
Customized testingStandard tests do not always satisfy our clients’ needs. The Tribology Lab continuously works on offering new test equipment able to simulate the final application more realistically. Some examples include:
Tribocorrosion tests: ■ Corrosion and wear in riser tensioner piston rods in
offshore applications.In situ tribology:
■ Analysis of contact area between sapphire and any counterpart by interferometry.
Photo: Thor Noelsen
