Retrokit Installation(en)
-
Upload
rizal-falevy -
Category
Documents
-
view
21 -
download
2
Transcript of Retrokit Installation(en)
RETROKIT SERIE E : Schematic installation Version 3 of 14/01/2008 ATTENTION : Check always if this is the most up-to-date version
HYPNOW SARL www.hypnow.fr
Heating of the bubbler :
- Exchanger on cooling engine (T°: 80° mini)
or - Installation on the exhaust pipe by clamps.
Bubbler eco 4L
(bubbler 12L optional)
Exhaust pipe
Air Filter Side
Rubber Air Intake Body
Motor Side or Turbo intake
Minimum Low pressure 150mm H2O
Drain valve included
- Air intake : may need air filter depending on setup -Fill with water ENGINE SHUT OFF
Connections : Bubbler / Reactor/ Diffuser
Flexible stainless steel, rubber or cupper pipes (Not supplied). Specification of accessories:
• Between Bubbler & Reactor : 1m length max. • Minimum Pipe Diameter :
- E1-45 : ND12 - E2-70 / E3-90 : ND16 - E4-100 : ND20
Installation of the Reactor on exhaust pipe : - E1-45 : Rectangular cut 20x70mm - E2-70 / E3-90 : 2 x Ø26 (distance 66mm) + 1 x Ø11 - E4-100 : 2 x Ø32 (entraxe 64mm) + 1 x Ø11
Water tank Water proof
(not supplied) : place it below the
bubbler.
Increased autonomy of water :
- Add a water tank , fill intermittently the bubbler by pump and temporary relay (optional).
- Feed by pressure (Network or motopump) on
the added water tank (for static engine) : install step by step : � Valve ¼ round � Filter 10µ, � Pressure reducer (1 bar) � Flow regulator (1 to 2 L/H) � Floating tap inside the water tank.
Temporary Relay
12Vcc
Water intake
Overflowing
Bubbler eco 4 litres : Dimensions : Hight: 290 mm Width : 240 mm Depth : 150mm Weight : 3,5 kg Bubbler 12 litres : Dimensions : Hight: 350 mm Width : 300mm Depth: 255 mm Weight : 8 kg
Reactor E1 : Fixed by 2 clamps Reactor E2, E3 and E4 : Fixed by nut H-M10.