Remote Control 433.920
4
Methods of operation for remote control Duplicate Your Existing Remote Controllers so you always have a backup: 1. Vehicle central locking systems 2. Garage doors 3. Electronic gates 4. Electrical appliances/Home automation i.e. lights Suitable for home use. If you want to use with car device, pls confirm they aren’t rolling code. Frequency: 433.92 MHz Can’t copy rolling codes. Works with the following remote control modules [please check your existing remote control before your operation]: 2262, 2260，1527，2240，5326 (If the suffix is the same, the performance is compatible. Such as SC2262 and PT2262.)
description
433.920 mhz learning remote , learning instructions
Transcript of Remote Control 433.920
Methods of operation for remote control
Duplicate Your Existing Remote Controllers so you always have
a backup:
1. Vehicle central locking systems
2. Garage doors
3. Electronic gates
4. Electrical appliances/Home automation i.e. lights
Suitable for home use. If you want to use with car device, pls
confirm they aren’t rolling code.
Frequency: 433.92 MHz
Can’t copy rolling codes. Works with the following remote
control modules [please check your existing remote control
before your operation]:
2262, 2260，1527，2240，5326(If the suffix is the same, the performance is compatible. Such as SC2262 and PT2262.)
1. Clear out code:
To Clear up test stored rf signal memory from factory by pressing the A and B at the same time, 3 seconds later, LED indicator light flashes three times, undo B and then click B three times quickly, following is a continuous fast blinking. Indicates that the remote control codes stored has been cleared out.
2. CheckingWhen you clear away the code, you can press any key on the remote control. If LED light do not blink immediately, but blink 2s later. That means kao coding has been completely clean.
3. Duplicating (learning)Hands are holding remote control , and the other are holding the duplicating remote control, 2 remote controls put together as close as possible, while pressing the remote controls two match button,(eg: A-A’,B-B’) three seconds later, LED indicator light flashes three times, followed by a continuous fast blinking. This indicates that this copy of the remote control buttons are same as copied on the remote control button codes. Several other keys are also according to the above approach to learning.
Attention: 1. Using this remote control before please be sure to clear the
existing code.
2. The key of the remote control and the be copied remote
control can be arbitrary. As long as both operations, after the
success, all the functions are the same.
3. There are some controllers equipped by the original
equipment manufacturers maybe can't copy.
4. Sometimes the frequency may have a little deviation.
You can adjust by yourself. And use frequency meter for test.
