Quick Start Guide TTGO Edition

7/31/2019 Quick Start Guide TTGO Edition

1/16

ENGLISH

navigating GmbH

Points-of-Interest-Warner[POI-Warner]

TomTom GO Edition

uick Start Guide


2/16

2

General Information

1

This document is supposed to help you through the installation of the POI-Warner with step-by-step instructions. Further on you receive solutions formost of the questions that can occur during the installation process andsupport while using the POI-Warner for the first time.

All information are without guarantee and serve only for support. It can not be taken over any liability fordamages of any kind caused through this document. @ 2003 All rights reserved, including the duplication,translation, microfilming as well as storing and processing in electronic systems.

Legend

1 Survey of the symbols used in this document.

1 Number of the respective main section

1 Number of the main section's corresponding subsection

1 Step successfully completed, continue with the next one

1 Additional problem solution, if the former one was unsuccessful


3/16

3

1 Installation

1 Connect yout TomTom device with your computer. Please check

whether the device is recognized by the system and listed as an USB-Drive.

2 The POI-Warner is installed on the Desktop first.After that the Desktop-Application installs the

Fhren Sie bitte die Setup-Datei des POI-Warners auf ihrem

Desktop-PC aus und folgen Sie den Bildschirmanweisungen.

3

After the Installation the POI-Warner Synchronization is runautomatically. Check the connection of your device to yourcomputer. Please follow the onscreen-instructions.

Possible problems SolutionsYou do not have thesetup.

Download the POI-Warner from this web-address:

TomTom GO Classic/300/500/700/One/Riderwww.navigating.de/poiwarnerttgo/setupttgo.exe

TomTom GO 510/710/910www.navigating.de/poiwarnerttgo/setupttgo_10.exe

Please restart at step 1.

Possible problems SolutionsThe device is notrecognized.

Please check the connection cable. Is the device inUSB mode and can you see a connected device onyour device screen? Is the device listed in windowsexplorer?

If you still have problems contact the support to get asolution.

Activation and configuration


4/16

4

4 The installation on the device follows now. Ensure that youve installed

TomTom firmware version 6 or higher on your device. You can install theproper firmware even after the installation of POI-Warner. Although POI-

Warner will function correctly only after the installation of the correctfirmware. Note that f irmware version 6.510 is not natively compatiblewith POI-Warner use the latest version instead.

To learn how you can obtain the latest version please visit TomTomswebsite.

http://www.tomtom.com/

5 Please select the map you want to synchronize for.

Possible problems SolutionsThe installation wasskipped due tocompatibility issues.

If you own a TomTom ONE or TomTom Rider this isnormal behaviour, because both devices are notcompatible to this version of the device-application.

The automatic desktop-computer synchronizationworks nevertheless.

The application tells meto unplug and replug thedevice, but nothingchanges after that. I cantproceed.

Most devices dont need this procedure. If you see thiswindow on your systems in necessary to let the deviceboot up until you see the map before you replug thecable. If you plug in too early the needed informationwont be created and the configuration could notproceed.

Possible problems SolutionsNo Maps are shown. Is there really a map installed on the device?

Is a SD-Card in the device (if not GO 700)?Is the device connected correctly and listed in windowsexplorer?

If you still have problems contact the support to get asolution.


5/16

5

6 You have done it! The desktop application was successfully installed. Top right

you can see you POI-Warner ID. You need this ID later.

To use POI-Warner you need to purchase it. Some services are also not free.

Please inform yourself at the specific poi-shop.

To buy POI-Warner visit please:

http://www.navigating.de/


6/16

6

2 Download/Synchronization of the overlays

1 Connect your device to your desktop-pc and run the synchronization-

application on your pc.

2 The list of the available overlays on the respective server is loaded

and displayed afterwards.

Download/Synchronization of the overlays


7/16

7

3 Please select a desired category on top of the page (after the list isdisplayed) and the desired overlays by marking them in the bottom partof the screen. You can switch arbitrarily between the different categoriesand the POI-Warner "remembers" your selections for every category forthe synchronization process. Please select only such overlays from thecategories for which you are activated (some of the overlays require anon free separate registration with the provider www.poihandler.com).

4 After the selection of the overlays, please click on the button

"Start Synchronization!". Then the overlays will be downloaded and

copied to the right directories automatically.

Possible problems Solutions

The POI-Warner can notestablish an internetconnection: The name ofthe server is shown ontop of the screen but allother fields (category andlist of the overlays)remain empty.

Please make sure that the computer has set up aninternet connection currently.

If the previous solution did not lead to success:A general connection problem can occur due to severalreasons; this includes environment-specificconfigurations and settings regarding networkconfiguration, proxy configuration, firewall configuration

or operating system configuration. The main problem inthis case is the identification of the responsiblecomponent. At first a connection test is necessarywhich could give a clue at least. Please accomplish theconnection test (specified in the appendix of thisdocument) and send the results to the support for thesynchronization: [email protected].



8/16

8

5 The system shows "State: last synchronization was successful" below

in the status indicator line.

Possible problems SolutionsThe POI-Warner can notestablish an internetconnection.

Look at the solution steps at 2.2.

The POI-Warner reports:The sync service for thisoverlay belongs to thenon free supply of thePOI service provider (orsimilar).

You are not registered for the non free overlays. Thenyou have to remove the overlay from the selection ofthe overlays that will be synchronized or register for theoverlay with the provider at www.poihandler.com.

If the previous solution did not lead to success:

You are registered for the overlay at poihandler.combut the notification appears nevertheless: Yourregistration data at poihandler.com are presumably not

updated yet. Please write to the operator of thesynchronization service ([email protected]) andgive him your current data (POI-Warner ID andtransaction number as well as the service to beactivated).



9/16

9

3 Download of weather data



2 You can see the main menu:

Download of weather data


10/16

10

3 Mark the box Download weather data left bottom in the window.

This Selection is remembered on every start of the application.

4 After clicking Start Synchronization weather data and selected overlays

will be downloaded and copied to the right places.


The POI-Warner can notestablish an internetconnection: The name ofthe server is shown ontop of the screen but allother fields (category andlist of the overlays)remain empty.

Please make sure that the computer has set up aninternet connection currently.

If the previous solution did not lead to success:A general connection problem can occur due to severalreasons; this includes environment-specificconfigurations and settings regarding networkconfiguration, proxy configuration, firewall configuration

or operating system configuration. The main problem inthis case is the identification of the responsiblecomponent. At first, a connection test is necessarywhich could at least give a clue. Please accomplish theconnection test (specified in the appendix of thisdocument) and send the results to the support for the

synchronization: [email protected].



11/16

11

5 The system shows "State: last synchronization was successful" below

in the status indicator line.


The POI-Warner can notestablish an internetconnection

Look at the solution steps at 2.2.

The POI-Warner reports:The sync service for theweather data is notregistered or outdated(or similar).

Weather data is included for 1 year. If this time spanran out you probably have to buy a new subscription.



12/16

12

4 Use of the Scheduler



2 You can see the main menu.

Activate the Box Run scheduler on Windows-Startup on the bottom ofthe window.

3 Choose the kind of synchronization desired:

a) None No automatic synchronizations will be done.b) On Connect Synchronization on every connection of the device

to the desktop pc.c) Daily Synchronization on every day and connection.d) Weekly Synchronization on every week and connection.e) Monthly Synchronization on every 30 days and connection.

4 Please restart your computer to activate the changes.

Use of the Scheduler


13/16

13

5 First configuration of Overlay-Warning

1 Make sure you synchronized the overlays you want to use.

2 Switch on your TomTom.

In normal cases all newly synchronised overlays are automatically addedto the display.

If this is not the case select the following menu items

- Change Settings-

(de-)activate POI

Choose all overlays you want to see on your map.

3 All overlays which are typical for acustic warning are automatically

selected. If you dont want a specific warning deactivate it using

- Mainmenu- POI-Warner Options- Select POI-Warning

and confirm the changes with Ok.

ATTENTION!

The warning of speed-cam overlays can be accusable in certaincountries.

Please check your countrys laws before you use this function.

First configuration of Overlay-Warning


14/16

14

6 First Setup of weather data on the device

1 Make sure you downloaded the weather data with the

POI-Warner synchronization-tool.

2 Switch on your TomTom.

Choose the following Menus:

- POI-Warner Weather

First setup of weather data on the device


15/16

15

3 If no city is already selected you need to select one first.

Choose Select City

Choose the city which should be your local city.

4 Choose Weather Today, Weather Tomorrow or Weather 5-Day .

Pay attention to the fact that Weather Route maybe need a destinationcity selected if it cannot get this information out of a programmed route.

Possible problems SolutionsA message appearswhich says that there is

no weather data.

Please make sure you downloaded weather data withthe synchronization-tool successfully and you do not

use data from another machine.

First setup of weather data on the device


16/16

16

Support Collecting the necessary information

1 Please collect the following information:

- Version of the used software POI-Warnero You can find this information on the Options-About

Screen on the device.o Used device and version of the used TomTom software

version

2 Product support for the POI-Warner:

Support navigating [email protected]

3 Product support and support area synchronization:

Marcel [email protected]: www.poihandler.comWebsite : www.poihandler.com

You can find more detailed instructions online atwww.navigating.de under

Documentation in the respective product area.

Collecting the necessary information

Quick Start Guide TTGO Edition

Documents

Transcript of Quick Start Guide TTGO Edition