Product: Lambda Light

Product portfolio of mounting systems

Mounting systems

On-roof In-roof Fat roof Open terrain

Tau

Alpha

Theta

Kappa

Zeta

Lambda Light

Lambda

Sigma I

Omega

Sigma II

Gamma

Mounting Systems GmbH Product portfolio

Stand 110530

Designed for flat roofs with limited permissible additional load capacitiy

• Aerodynamic, optimized system, requirering substantially less ballast than conventional flat roof systems

• Intelligent, interlocking system – Few single components– Simple installation

• Comprehensive project support – For efficient quotation and planning– For statical security

Lambda Light Flat roof system

Stand 110530

Lambda Light – Flexible, efficient, safe

• Suitable for configurations of min. 2 rows

– Min. 10m²– Lowest ballast categories red

at configurationachesErreichung der ni of min.5x5 modules

– The bigger the installation, the lower the average additional load

• For landscape installation of framed modules

• Standard pitch: 15° (others on request)

Stand 110530

Lambda Light – components

• Protective mat

• Ground profile

• Pitched profile

• Back sheet

• Side flashing

• Base rail with clamp and joiner piece

• Module end clamps

• Small parts

Stand 110530

Lambda Light – Principle of a light-ballasted system

• Reduction of the regular load requirements exacted in the applicable regulations and standards for wind loads through

– Interconnection of all system parts– Aerodynamically advantageous design

• Low landscape orientation• Lateral and back closures• Specific gap on top

• Planning safety through– Wind channel testing, FEM-calculations– Tests for applicable sliding values

=> Many roofs with limited permissible additional load capacity can be used for PV installation; formerly unsuited roofs become potential ‚PV-roofs‘

Stand 110530

Lambda Light – Support

• Planning process more complex than traditionally, due to higher security risks in case of misinterpretation

• High Mounting Systems support level:

– Support for the configuration of the installation, including roof-specific testing of sliding

– Detailed calculation of necessary ballast– Exact layout plan for all components

Stand 110530

Lambda – clever details 1

• Main components made of Aluminium sheets:– Combining low weight and high resistance

• Simple transport• Low quantities of material

– Dubble corrucation of ground profile provides space for ballast

– Great optics

• Keyhole – type fixing spaces for rapid and safe installation of the clamps

• Upstands in the ground profiles facilitate exact positionning

– Short installation times, exact overlap withoutmeasuring

Stand 110530

Lambda – clever details 2

• Selfdrilling screws; no metal slivers– Protection of the roof

• Universal module end clamp – Proven Quickstone technology– One component for all frame heights

• Version without module support rail– For modules that can be clamped at the corners– Cost reduction by approx. 15%

Stand 110530

Lambda Light – at a glance

• Light ballasted system for landsccape installation of framed modules, especially suited for big installations

• Status of product launch– Testprojects successfully installed– Start of standard sales in Q3/4

• Clevere design:– Few, lightweight components– Modular system, built for speady

installation– Competent support

Thank you for your attention.