Official Mn 121 Final Project Staircase
description
Transcript of Official Mn 121 Final Project Staircase
By: Dennis Lee & Wojciech Kimborowicz
SOLID WORKS
The Staircase
assemble was
designed in
SOLIDWORKS.
It consists of six 3D
models
Bracket
Universal Bracket is used to support a staircase step, 2 are required per 1 step.
DETAIL
Universal Bracket is used to support a staircase step, 2 are required per 1 step.
(2) 2x6 are used in this assembly, they are the skeletons of the staircase. They have a 45° cuts on each end.
(2) 2x6 are used in this assembly, they are the skeletons of the staircase. They have a 45° cuts on each end.
Step can be used of all
kinds of wood, in our
case we used Oak.
Step can be used of all
kinds of wood, in our
case we used Oak.
A 1” Phillips screw
was used to Bind all
the Parts together
A 1” Phillips screw
was used to Bind all
the Parts together
No. Description QTY.
1 Support Bracket 8
2 2x6 Beans 2
3 1” Phillips screw 16
4 Oak Baseboard 91/2 X 36” 4
5 Floor (reference only) 1
6 Wall (reference only) 1
Bill Of Material