OF110029 R02_LHL Brochure Low Res
2
e Energy Flows rough Us™ HYDRAULIC LIFT Hydraulic Pumping Unit LUFKIN.COM/LHL OF11-0029-R02 Natural Gas or Diesel Engine Electric Motor Known as a leader and innovator in artificial liſt solutions, Luin continues the tradition with the introduction of the Hydraulic Pumping Unit (HPU) from its Hydraulic Liſt division. is innovative solution employs patented rod string management technology, featuring three limit switches positioned on the tower to monitor the exact position of the rod string. e data is then processed by Luin’s proven controller to precisely deliver hydraulic fluid through the proportioning valve to optimize every stroke and accurately regulate the stroke rate between one half and four strokes-per-minute. q HPU installations have increased production by as much as 300% q Proven track record in gas well deliquification q The pump rate matches a well’s natural feed in rate q Provides more efficient operation of the downhole rod pump q Optimizes well production With a minimal footprint, rapid installation and few moving parts, the HPU provides a cost-effective solution for dewatering low volume oil and natural gas wells. We design these units with flexibility in mind and offer natural gas, diesel and electric prime movers to meet your unique requirements. ese units deliver a stroke length up to 168 inches and achieve 30,500 lbs peak polish rod load. Power units are available as skids or enclosures for environments where noise and security are a concern. What is Hydraulic Rod Lift? e Luin HPU uses a hydraulic piston to vertically liſt the fluid from the well. UP STROKE: Hydraulic Liſt DOWN STROKE: Controlled descent using rod string weight Producing Impressive Results Designed for Flexibility System Performance Challenge: In Late 2010 plunger lift production was reduced to zero with a significant decline in bottom hole pressure. Solution: Lufkin Hydraulic Lift Unit 300-168 enclosed natural gas unit installed February 2012. Result: Total production was restored to 2008 initial rates of 600+ Mcf/d Gas and 30+ BOPD Oil.
description
Brochure
Transcript of OF110029 R02_LHL Brochure Low Res
� e Energy Flows � rough Us™
HYDRAULIC LIFT
Hydraulic Pumping Unit
LUFKIN.COM/LHLOF11-0029-R02
Natural Gas or Diesel Engine Electric Motor
Known as a leader and innovator in arti� cial li� solutions, Lu� in continues the tradition with the introduction of the Hydraulic Pumping Unit (HPU) from its Hydraulic Li� division. � is innovative solution employs patented rod string management technology, featuring three limit switches positioned on the tower to monitor the exact position of the rod string. � e data is then processed by Lu� in’s proven controller to precisely deliver hydraulic � uid through the proportioning valve to optimize every stroke and accurately regulate the stroke rate between one half and four strokes-per-minute.
q HPU installations have increased production by as much as 300%
q Proven track record in gas well deliquifi cationq The pump rate matches a well’s natural feed in rateq Provides more effi cient operation of the downhole rod
pumpq Optimizes well production
With a minimal footprint, rapid installation and few moving parts, the HPU provides a cost-e� ective solution for dewatering low volume oil and natural gas wells. We design these units with � exibility in mind and o� er natural gas, diesel and electric prime movers to meet your unique requirements. � ese units deliver a stroke length up to 168 inches and achieve 30,500 lbs peak polish rod load. Power units are available as skids or enclosures for environments where noise and security are a concern.
What is Hydraulic Rod Lift?� e Lu� in HPU uses a hydraulic piston to vertically li� the � uid from the well.
UP STROKE: Hydraulic Li�
DOWN STROKE: Controlled descent using rod string weight
Producing Impressive Results
Designed for Flexibility
System Performance
Challenge: In Late 2010 plunger lift production was reduced to zero with a signi� cant decline in bottom hole pressure.
Solution: Lufkin Hydraulic Lift Unit 300-168 enclosed natural gas unit installed February 2012.
Result: Total production was restored to 2008 initial rates of 600+ Mcf/d Gas and 30+ BOPD Oil.
©2012 Lufkin Industries, Inc. All rights reserved. OF11-0029-R02
Hydraulic Pumping Unit
Rod String Management Technology� e patented Lu� in rod string management technology extends the life of your rod string by slowing the descent as it approaches the bottom of the stroke to allow the rod’s elasticity to adjust naturally into the up stroke to minimize rod reversal e� ects.
Headquarters/Manufacturing1320 Petroleum ParkwayBroussard, LA 70518Phone: 337-364-5588Fax: 337-364-5579
Rapid Installation
Minimal Rod Preparation Attach Tower Connect Power Unit to Tower
Attach and Adjust Limit Switches
Set Power Unit in Place
Sales5825 North Sam Houston Parkway West, Suite 500Houston, TX 77086Phone: 281-875-6500Fax: 281-875-4236
20000
15000
10000
5000
0 50 100 150
0
-5000
Position (in)
Load (lbs)
Dyno Surface and Pump Cards and Permissible Loads
Features & Benefi tsq Quick setup & takedown - approximately 3 hoursq Reduced rod wearq Change lift speeds instantaneouslyq Controlled deceleration with Plus +1 Controllerq Ability to safely & quickly tag bottomq Fewer moving partsq Minimal pinch pointsq Minimal human and animal hazardsq Minimal site prep workq Small footprint
Specifi cationsq Stroke length: 72 inches to 168 inchesq Strokes per minute: 1/2 to 4 spmq Maximum lift: 30,500 lbs peak polish rod load
Under Developmentq 300 inch long strokeq 45,000+ lbs peak polish rod load
Contact LHL E-mail: [email protected]
Hydraulic Pumping Unit
Rod String Management Technology� e patented Lu� in rod string management technology extends the life of your rod string by slowing the descent as it approaches the bottom of the stroke to allow the rod’s elasticity to adjust naturally into the up stroke to minimize rod reversal e� ects.
Rapid Installation
Minimal Rod Preparation
Upper Limit SwitchMagnetic sensor recognizes the top of the stroke when actuator reaches it. Hydraulic lift stopsto allow controlled descent using rod string weight.
Upper Limit SwitchMagnetic sensor recognizes the top of the stroke when actuator reaches it. Hydraulic lift stopsto allow controlled descent using rod
Deceleration Limit SwitchMagnetic sensor alerts control to slow rod descent to minimize stress on rod string at bottom of stroke.
Deceleration Limit SwitchMagnetic sensor alerts control to slow rod descent to minimize stress on rod string at bottom of stroke.
ActuatorMagnetic sensors measure the position of the actuator throughout the entire length of each stroke.
ActuatorMagnetic sensors measure the position of the actuator throughout the entire length of each stroke.
Lower Limit SwitchMagnetic sensor alerts control to begin hydraulic lift for next up stroke.
Lower Limit SwitchMagnetic sensor alerts control to begin hydraulic lift for next up stroke.
Long slow strokes reduce tubing and rod wear
LUFKIN.COM/LHL
