NORMARC NAV Analyzer - Indra · 2019. 6. 3. · NORMARC family of navigational aids. NORMARC NAV...
Transcript of NORMARC NAV Analyzer - Indra · 2019. 6. 3. · NORMARC family of navigational aids. NORMARC NAV...
Safe flight and landings depend onaccurate navigational aids.
The NORMARC 7710 NAV Analyzer letsyou see the real performance of your ILSand VOR with results you can trust.The NORMARC label is your guarantee forthe same unsurpassed accuracy, reliabilityand integrity that characterizes the NORMARC family of navigational aids.
NORMARCNAV AnalyzerReliable and portable navaids testing
Indra Navia AS
Hagaløkkveien 26NO-1383 Asker, NorwayT +47 23 18 02 [email protected]
Robust and accurate
The NORMARC 7710 NAV Analyzer provides the high accuracy and measure-ment speed needed for ground and flight inspection of Instrument Landing System (ILS) localizer, glide path, marker beacon, and very high frequency omni-directional range (VOR).
Lightweight and portable, the NAV Analyzer can be used under any weather condition and is protected against damage during transport. It is battery powered with a capacity of more than 6 hours of operation.
Several instruments in one unit
The NORMARC 7710 NAV Analyzer replaces instruments like ILS/VOR receivers, modulation meters and frequency counters with a single unit.
The NAV Analyzer is weatherproof and can be used outdoors, in a vehicle or inside the equipment shelter for efficient and reliable ILS and VOR testing, verification, and troubleshooting. It incorporates all ILS and VOR channels selectable without any tuning or equipment changes. Full control from a remote system is possible.
The same accuracy, reliability and integrity that characterizes the NORMARC family of navigational aids.
Features
Performance analysis of ILS localizer, glide path,
marker beacon and VOR
Supports CAT III ILS localizer in accordance with
ICAO 8071
Low weight and small size
Automatic tuning to the input signal
More than 6 hours’ operation from fully charged
condition
Data storage capacity for minimum 1 hour of
continuous measurements
Charging from 10.8-30V DC source directly or
110-240V AC
User named measuring points/sequences and
selectable measurement intervals/rates
All controls and measurements available through
external interfaces
RS-232 or Ethernet interface for external data
access
Dual-band antenna
Connector for external event button