Model 895 APDISSASSEMBLY AND ASSEMBLY

1. DisassemblyTo replace the spring or clean any internal components of the valve, proceed in the following manner:A. Cut the seal thread with pliers.B. Withdraw the fastener, using a punching tool, until the lever comes free.C. Unscrew and extract the hood.D. Holding the rod, unscrew the spring press, until you note a releasing of the spring.E. Extract the spring.

2. AssemblyA. Enter the spring through the upper part of the rod.B. Screw the spring press holding the rod.C. Adjust the set pressure with the spring press.D. Screw the hood.E. Place the lever and fix it with the fastener.

Model 895 APADJUST THE FIRING PRESSURE

A. Cut the seal thread with pliers.

B. Withdraw the fastener, using a punching tool, until the lever comes free.

C. Unscrew and extract the hood.

D. Holding the rod, unscrew the spring press, until you note a releasing of the

spring.

ImportantWe advice that the adjustment or readjustment of the set pressure and the exchange of the seal should be done in our installations, with the original and warranted spare parts.