Limits and Their Properties · Although precalculus mathematics also deals with velocities,...
Transcript of Limits and Their Properties · Although precalculus mathematics also deals with velocities,...
Limits and Their Properties1
Copyright © Cengage Learning. All rights reserved.
A Preview of Calculus
Copyright © Cengage Learning. All rights reserved.
1.1
3
What Is Calculus?
4
Calculus is the mathematics of change. For instance,
calculus is the mathematics of velocities, accelerations,
tangent lines, slopes, areas, volumes, arc lengths,
centroids, curvatures, and a variety of other concepts that
have enabled scientists, engineers, and economists to
model real-life situations.
Although precalculus mathematics also deals with
velocities, accelerations, tangent lines, slopes, and so on,
there is a fundamental difference between precalculus
mathematics and calculus.
Precalculus mathematics is more static, whereas calculus
is more dynamic.
Calculus
5
Precalculus concepts
6
cont’dPrecalculus concepts
7
Precalculus conceptscont’d
8
Precalculus conceptscont’d
9
Finding Limits Graphically
and Numerically
Copyright © Cengage Learning. All rights reserved.
1.2
10
Estimate a limit using a numerical or
graphical approach. (GNAW on Calculus)
Learn different ways that a limit can fail to
exist.
Objectives
11
An Introduction to Limits
What is a limit?
12
Suppose you are asked to sketch the graph of the function
f given by
For all values other than x = 1, you can use standard
curve-sketching techniques.
However, at x = 1, it is not clear what to expect.
An Introduction to Limits
13
An Introduction to Limits
• To get an idea of the behavior of the graph
of f near x = 1, you can use two sets of x-
values–one set that approaches 1 from the
left and one set that approaches 1 from the
right, as shown in the table.
x 0.75 1 1.25
f(x)
14
To get an idea of the behavior of the graph of f near x = 1,
you can use two sets of x-values–one set that approaches
1 from the left and one set that approaches 1 from the right,
as shown in the table.
An Introduction to Limits
15
The graph of f is a parabola that
has a gap at the point (1, 3), as
shown in the figure at the right.
Although x can not equal 1, you
can move arbitrarily close to 1,
and as a result f(x) moves
arbitrarily close to 3.
Using limit notation, you can write
An Introduction to Limits
This is read as “the limit of f(x) as x approaches 1 is 3.”
16
An Introduction to Limits
This discussion leads to an informal definition of limit.
If f(x) becomes arbitrarily close to a single number L as x
approaches c from either side, the limit of f(x), as x
approaches c, is L.
This limit is written as
17
Limits That Fail to Exist
18
Solution:
Consider the graph of the function . From the
graph shown and the definition of absolute value
Example 3 – Behavior That Differs from the Right and from the Left
Show that the limit does not exist.
you can see that
19
Limits That Fail to Exist
What about f(x) increasing or decreasing
without bound as x approaches c?
20
Limits That Fail to Exist
What about f(x) increasing or decreasing
without bound as x approaches c?
21
Does the limit exist?
DNE
2
2
2
0
DNE
-3
0
22
• Finding limits for piece-wise functions:
Find -4
-5
DNE
-13
Plug -1 into top two equations &
see if they give the same value.
Plug 0 into middle equation.
Plug 3 into bottom two equations
& see if they give the same value.
Plug -4 into top equation.
23
Evaluating Limits Analytically
Copyright © Cengage Learning. All rights reserved.
1.3
24
Develop and use a strategy for finding limits.
Evaluate a limit using dividing out (factor and
cancel) and rationalizing techniques.
Objectives
25
Remember this function?
Could we have figured
out the limit as x
approaches 1 without
graphing or
doing a table?
An Introduction to Limits
26
Because exists, you can conclude that f and g
have the same limit at x = 1.
Example 6 – Solution cont’d
27
Example 6 – Solution
So, for all x-values other than x = 1, the functions f and g
agree, as shown in the figures below.
cont’d
f and g agree at all but one point
28
Limits
• So
• But what about:
or
= 1
= 3
29
Limits• The first thing we do when finding limits
is to try plugging in the x to see what y
value we get. (See pages 59-61 for
properties & example.)
• If you can’t plug in the x, then try doing
some algebra and then see if you can
plug in the x, (factor & cancel, or
rationalize).
• If that doesn’t work, use a graph or table
to determine the limit.
30
Example 1 – Evaluating Basic Limits
31
Find the limit:
Example 3 – The Limit of a Rational Function
32
Example 4(a) – The Limit of a Composite Function
33
Example 4(b) – The Limit of a Composite Function
34
Example 5 – Limits of Trigonometric Functions
35
Example 7 – Dividing Out (factor & cancel)
Find the limit:
What happens to the numerator and the denominator when
you plug in the -3?
It is an indeterminate form because
you cannot (from the form alone)
determine the limit. (When you plug
in x = -3, you get the fraction 0/0
which is undefined.)
36
Because you get a 0 when you plug in -3 in both the
numerator and denominator, then they have a common
factor. For this example it is (x + 3).
So, for all x ≠ –3, you can divide out this factor to obtain
It follows that:
Example 7 – Solutioncont’d
37
This result is shown graphically in the figure below.
Note that the graph of the function f coincides with the
graph of the function g(x) = x – 2, except that the graph of f
has a gap at the point (–3, –5).
Example 7 – Solutioncont’d
38
Rationalizing Technique
(another way to simplify)
39
Find the limit:
(By direct substitution, you obtain the indeterminate form 0/0.
Example 8 – Rationalizing Technique
40
In this case, you can rewrite the fraction by rationalizing the
numerator.
cont’dExample 8 – Solution
(Continued on next page)
41
Now you can evaluate the limit as shown.
cont’dExample 8 – Solution
42
A table or a graph can reinforce your conclusion that the
limit is .
Example 8 – Solutioncont’d
43
Review:• The first thing we do when finding limits
is to try plugging in the x to see what y
value we get.
• If you can’t plug in the x, then try doing
some algebra and then see if you can
plug in the x, (factor & cancel, or
rationalize).
• If that doesn’t work, use a graph or table
to determine the limit.