Lecture 4 iium drawing for engineer
-
Upload
muhamad-azfar -
Category
Documents
-
view
15 -
download
2
description
Transcript of Lecture 4 iium drawing for engineer
MUTLIVIEW PROJECTIONS
Engineering Drawing (MME 1211) LECTURE-4
Kulliyyah of EngineeringInternational Islamic University Malaysia1Dr. Rubina BaharRoom: E1-5-8.13Email: [email protected] 4Missing View problems andIsometric Drawing2Sketching: Sketching Line Types3
Object sketching4
Isometric view sketching5
Some Examples6
7
8
Sketching an isometric circle9
Draw using instruments, the given two views and add the third view. Sketch the Isometric view of the component. Unit = inch.
10PRACTICE AT HOME11Sketch the views of the object (a) in 3rd angle projection. Redraw the given three views of object (b); add the missing lines and sketch the isometric view of the object. Select a suitable scale of your choice.
(a)(b)PRACTICE AT HOME12Sketch the views of the object (a) in 3rd angle projection. Redraw the given front and right-side views of object (b), add the top view and sketch the isometric view of the object. Select a suitable scale of your choice.
(a)(b)PRACTICE AT HOMECLASS ASSIGNMENT-C3W413
TWO views of a block are shown in figure. 1. Redraw the two given views and add the TOP view of the block. 2.Draw a full size isometric view of the block. The size of grid is 10 mm x 10 mm.FRONTRIGHT