Ice water content from radar reflectivity factor and temperature

16
Robin Hogan Anthony Illingworth Marion Mittermaier Ice water content from radar reflectivity factor and temperature

description

Ice water content from radar reflectivity factor and temperature. Robin Hogan Anthony Illingworth Marion Mittermaier. Overview. Use of mass-size relationships in calculating Z from aircraft size spectra in ice clouds Radar-aircraft comparisons of Z - PowerPoint PPT Presentation

Transcript of Ice water content from radar reflectivity factor and temperature

Page 1: Ice water content from radar reflectivity factor and temperature

Robin HoganAnthony IllingworthMarion Mittermaier

Ice water content from radar reflectivity factor

and temperature

Page 2: Ice water content from radar reflectivity factor and temperature

Overview• Use of mass-size relationships in calculating Z from

aircraft size spectra in ice clouds• Radar-aircraft comparisons of Z• Derivation of IWC(Z,T): Rayleigh scattering• Evaluation of model IWC in precipitating cases using

3 GHz radar data• The problem of non-Rayleigh scattering• Derivation of IWC(Z,T): non-Rayleigh scattering

Page 3: Ice water content from radar reflectivity factor and temperature

Interpretation of aircraft size spectra

• To use aircraft size distributions to derive IWC(Z,T), need to be confident of mass-size relationship

• Brown and Francis used m=0.0185D1.9 (SI units)– It produced the best agreement between IWC from size

spectra and from independent bulk measurement– But can we use it for calculating radar reflectivity factor?

• Use scanning 3 GHz data from Chilbolton during the Clouds, Water Vapour and Climate (CWVC) and Cloud Lidar and Radar Experiment (CLARE’98)

• Rayleigh-scattering Z prop. to mass squared– Error in mass-size relationship of factor of 2 would lead to a

6 dB disagreement in radar-measured and aircraft-calculated values!

Page 4: Ice water content from radar reflectivity factor and temperature

Comparisons from CLARE’98

T=-32ºC, Z=-0.7dB, m=-8% T=-15ºC, Z=-1.0dB, m=-11%

Page 5: Ice water content from radar reflectivity factor and temperature

Comparisons from CWVC

T=-21ºC, Z=+0.3dB, m=+3% T=-10ºC, Z=+0.3dB, m=+4%

Page 6: Ice water content from radar reflectivity factor and temperature

Another CLARE case

T=-7ºC, Z=+3.7dB, m=+54%Implies particle mass/density is

up to factor 2 too small

But this case was mixed-phase: liquid water leads to riming and depositional growth rather than aggregation: higher density

Page 7: Ice water content from radar reflectivity factor and temperature

3 GHz

Mean slope: IWC~Z0.6

Page 8: Ice water content from radar reflectivity factor and temperature

Relationship for Rayleigh scattering

• Relationship derived for Rayleigh-scattering radars:– log10(IWC) = 0.06Z – 0.0197T – 1.70 i.e. IWC Z 0.6f(T )

• What is the origin of the temperature relationship?• For an exponential distribution with density D-1:

– IWC N0D03 and Z N0D0

5

• If T is a proxy for D0 then eliminate N0:

– IWC Z D0-2 Z f(T )

– Not observed!

• If T is a proxy for N0 then eliminate D0:

– IWC Z 0.6N00.4 Z 0.6f(T )

– Correct!

Observations by Field et al. (2004) demonstrate the T dependence of N0

Page 9: Ice water content from radar reflectivity factor and temperature

IWC evaluation using 3 GHz radar

• Now evaluate Met Office mesoscale model in raining events using Chilbolton 3 GHz radar

• Advantages over cloud radar:– Rayleigh scattering: Z easier to interpret– Very low attenuation: retrievals possible above rain/melting

ice– Radar calibration to 0.5 dB using Goddard et al. (1994)

technique– Scanning capability allows representative sample of gridbox

• 39 hours of data from 8 frontal events in 2000• Apply IWC(Z,T) relationship and average data in

horizontal scans to model grid • Threshold observations & model at 0.2 mm/h

– Need to be aware of radar sensitivity; only use data closer than 36 km where minimum detectable reflectivity is –11 dBZ

Page 10: Ice water content from radar reflectivity factor and temperature

Comparison of mean IWC• Results:

– Accurate to 10% between –10ºC and -30ºC

– Factor of 2 too low between -30ºC and -45ºC

– Results at colder temperatures unreliable due to sensitivity

sensitivityat 10 km

sensitivity

at 36 km

Page 11: Ice water content from radar reflectivity factor and temperature

Comparison of IWC distribution

• Distribution generally too narrow in model, problem worse at warmer temperatures

Page 12: Ice water content from radar reflectivity factor and temperature

Non-Rayleigh scattering• Representation of Mie scattering has large effect…

Mie-scattering using equivalent area diameterMie-scattering using mean of max dimensions

Equivalent-area diameter

Mean of max dimensions

Typical aircraft crystal image

Page 13: Ice water content from radar reflectivity factor and temperature

35 GHz

Non-Rayleigh scattering

log10(IWC) =

0.000242 ZT + 0.0699 Z– 0.0186T– 1.63

Page 14: Ice water content from radar reflectivity factor and temperature

log10(IWC) =

0.000580 ZT + 0.0923 Z– 0.00706T– 0.992

94 GHz

Non-Rayleigh scattering

Page 15: Ice water content from radar reflectivity factor and temperature

Ice water

Observations

Met Office

Mesoscale Model

ECMWF

Global Model

Meteo-France

ARPEGE Model

KNMI

RACMO Model

Swedish

RCA Model

Page 16: Ice water content from radar reflectivity factor and temperature

•The linear regression fit in log-space of all data is close to the 1 to 1 line.

•The distribution is wide and not symmetric

Comparison of the IWC products (lidar/radar vs. Z,T) Comparison of the IWC products (lidar/radar vs. Z,T) retrieved from Chilbolton data (2003) retrieved from Chilbolton data (2003)

IWCZT =IWC

Linear regression