Holeyboard 123 Instructions rev3 for web · 2020. 4. 22. · Attach the rubber feet using: Big Tall...
2
Attach the rubber feet using: Big Tall Screws, Big hex nuts and short and tall rubber feet. See chart on this page for feet locations Attach the feet to the locations below. Attach 2 TALL Feet to Module #1 Attach 4 SHORT Feet to Module #2 Attach Z-Connector with tiny screws and small keps nuts Attach 5 Feet to Module #3 Note: If putting on the left side use Short Feet if putting on the right side use Tall Feet. (The 4th foot is back here) 1 2 B. Flip rubber foot over, so the tiny hole is against the Holeyboard. Push screw through the countersunk hole on the top of the Holeyboard and push into the small rubber hole while tightening with the screwdriver until the nut catches, then tighten until the Rubber Foot is snug against the Base. A. Press the M6 hex nut into the bottom of the rubber foot’s large hole using your fingers or a phillips screw driver. A B
Transcript of Holeyboard 123 Instructions rev3 for web · 2020. 4. 22. · Attach the rubber feet using: Big Tall...
Attach the rubber feet using: Big Tall Screws, Big hex nuts and short and tall rubber feet. See chart on this page for feet locations
Attach the feet to the locations below.
Attach 2 TALL Feet to Module #1
Attach 4 SHORT Feet to Module #2
Attach Z-Connector with tiny screws and small keps nuts
Attach 5 Feet to Module #3Note: If putting on the left side use Short Feet if putting on the right side use Tall Feet.
(The 4th foot is back here)
1 2
B. Flip rubber foot over, so the tiny hole is against the Holeyboard. Push screw through the countersunk hole on the top of the Holeyboard and push into the small rubber hole while tightening with the screwdriver until the nut catches, then tighten until the Rubber Foot is snug against the Base.
A. Press the M6 hex nut into the bottom of the rubber foot’s large hole using your fingers or a phillips screw driver.
A
B
Attach 5 Feet to Module #3Note: If putting on the left side use Short Feet if putting on the right side use Tall Feet.
Use 2 Large Short Screws with 2 Large Keps nuts to attach Modules #1 and #2 together after choosing size by sliding until holes match up. 3
Check out my videos called “Holeyboard 123 Pedalboard Setup”and then watch “Holeyboard 123 Tips and Tricks”. It is on my website under “Videos” at www.holeyboardpedalboards.com It’s the easiest way to get you started. -Chris
NOTE: Depending on the components you ordered, you may have varying numbers of the parts below.
Z-Connector
Module #2
Module #3
Module #1
Hardware9 Short Rubber Feet9 Tall Rubber Feet12 Large Tall Screws2 Large Short Screws
4 Tiny Screws12 Large Hex Nuts2 Large Keps Nuts4 Small Keps Nuts2 Rubber C-Channel back feet
Pedalboards 123
Patent #US20170098438A1 Licensed from D’Addario Inc.
Copyright 2020 Chemistry Design Werks, LLC
Chemistry Design Werks2642 Univerisity Ave W STE 27Saint Paul, MN 55114
A) Watch the Setup Video
B) Lay Out Parts
Add and remove power supplies and effects pedals at will using included zip ties or Hook & Loop.
2 Adjustment screws go here.
Push on 2 Rubber Back Feet on each side
