Giben America, Inc. | 2915 Courtyards Drive Suite C, Norcross, GA 30071770-448-9140 | Fax 770-448-9133 | www.giben.com | sales@giben.com

Saw blade projection 75mm or 90mm

Length of cut 3300 mm or 3800mm

Main saw motor 15 Hp (75mm)

20 Hp (90mm)

Saw carriage speed 5-80 m/min (75mm)

5-150 m/min (90mm)

Pusher 0-80 m/min

Voltage 480 / 3ph / 60Hz

Controller G-Vision XP

On Board Optimizer Included

Giben America, Inc. | 2915 Courtyards Drive Suite C, Norcross, GA 30071 | 770-448-9140 | Fax 770-448-9133 | www.giben.com | sales@giben.com

THE SAW CARRIAGE travels on two parallel cylindrical

guide bars, positioned on a horizontal plane. Large

diameter “V” rollers (86 mm), with spring loaded

counter rollers, provide smooth linear travel of the saw

carriage, providing optimal distribution of the loads and

weights, very low contact pressure and is virtually free

from wear. The weight and loads acting on the saw

carriage are equally distributed between all the saw

carriage rollers. The saw carriage runs absolutely dry

on its guide bars, and no lubrication or adjustment is

required.

This construction concept has been used and trusted

by Giben for over 30 years and guarantees the

maximum structural rigidity and stability during the

cut cycle.

GRIPPER WITH FLOATING ACTION. The grippers clamp

the primary material book during the working cycle.

3300 cutting length equipped with seven

3800 cutting length equipped with eight

AIR FLOTATION TABLES make material handling light

and easy, which helps to keep the operator efficiency at

the maximum. The air flotation tables are powered by

one large capacity fan, located away from the operator

area.

FRONT AND REAR SQUARE FENCE made of steel on

the left side of the saw bed placed at 90° in respect to

the cutting line.