GG2 Antenna Module Specification_A-Rev1
-
Upload
claudiomatosbr -
Category
Documents
-
view
224 -
download
0
Transcript of GG2 Antenna Module Specification_A-Rev1
-
8/8/2019 GG2 Antenna Module Specification_A-Rev1
1/12
Tolerances (Unless otherwise specified)X :
X.X :
X.XX :
Angle :
Hole Dia. :
Unictron Technologies CorporationWebsite:www.unictron.com
Scale : Unit mm
Prepared By :Andy Checked By :Joe
Designed By :Hsin Approved By :Jaixing
THIS SPECIFICATION IS THE PROPERTY OF UNICTRONTECHNOLOGIES CORPORATION AND SHALL NOT BE REPRODUCEDOR USED IN ALL CIRCUMSTANCES WITHOUT WRITTEN PERMISSION
DOCUMENT REV.TITLE GG2 Active Antenna EngineeringSpecification NO.
9019GG21129900002A
PAGE 1 OF 12
G G 2 1 09 9 0 0 0 21 2
(1) (2) (3) (4) (5) (6) (7) (8) (9) (10) (11)
GG2 Antenna Module Engineering Specification
1. Explanation of Product Number
Product Code:(1) Product type:
G: GPS(2) Series code:
G2(3) Input voltage:
1: 3.00.5v(4) Length of cable:
1: 332mm(5) Cable type:
2: Kurabe ( =1.13mm) or Hitachi ( =1.13mm)(6) Connecter:
99: IPX MHF (for Hirose UFL) or TYCO mini RF connector (for Hirose UFL)
(7) Radome:0: Not required1: Required
(8) Label:0: Not required
-
8/8/2019 GG2 Antenna Module Specification_A-Rev1
2/12
Tolerances (Unless otherwise specified)X : X.X : X.XX : Angle : Hole Dia. :
Unictron Technologies CorporationWebsite:www.unictron.com
Scale : Unit mm
Prepared By :Andy Checked By :Joe
Designed By :Hsin Approved By :Jaixing
THIS SPECIFICATION IS THE PROPERTY OF UNICTRONTECHNOLOGIES CORPORATION AND SHALL NOT BE REPRODUCEDOR USED IN ALL CIRCUMSTANCES WITHOUT WRITTEN PERMISSION
DOCUMENT REV.TITLE GG2 Active Antenna EngineeringSpecification NO.
9019GG21129900002A
PAGE 2 OF 12
1: Required(9) Nonskid pad:
0: Not required1: Required
(10) Mounting ground plane:0: No
1: Yes(11) Filter:
0: No filter1: Dielectric filter2: Saw filter
2. Application:This application shall apply for antenna unit which shall be used with an GPS engine fora hand-held product (for impedance 50 ).
3. Appearance:Antenna Unit with connector and cable refer to the drawing attached
Dimensions 16.0x6.0x6.9mmWeight 3.2 0.3 g (typical)
4. Operating Condition:Temperature -40 to +85 C
Humidity 10 to 95% RH
5. Storage Condition:Temperature -40 to +90 C
Humidity 10 to 95% RH
-
8/8/2019 GG2 Antenna Module Specification_A-Rev1
3/12
Tolerances (Unless otherwise specified)X : X.X : X.XX : Angle : Hole Dia. :
Unictron Technologies CorporationWebsite:www.unictron.com
Scale : Unit mm
Prepared By :Andy Checked By :Joe
Designed By :Hsin Approved By :Jaixing
THIS SPECIFICATION IS THE PROPERTY OF UNICTRONTECHNOLOGIES CORPORATION AND SHALL NOT BE REPRODUCEDOR USED IN ALL CIRCUMSTANCES WITHOUT WRITTEN PERMISSION
DOCUMENT REV.TITLE GG2 Active Antenna EngineeringSpecification NO.
9019GG21129900002A
PAGE 3 OF 12
6. Electrical Specification:All values are defined at 25 15 C, 65 20 % RH, power handling 1 w, air pressure960 100 HPA unless otherwise noted.
6-1) Patch antenna
Characteristics Specification
Center Frequency 1575.421.023 MHz (when covered with a radomeand measured on LNA ground plane)Bandwidth(10dB return loss) 9 MHz typical
Gain at Zenith - 4 dBic typicalGain at 10 o elevation - 6 dBic typicalPolarization R.H.C.P
Axial Ratio 3.0 dB typicalPatch size 16x6x4mm
6-2) LNA
Characteristics Specification
Center Frequency 1575.421.023 MHzGain 27 dB min at 3VNoise Figure 0.7dB at 3V
Filter (Out of band attenuation)
Saw filter40dB typical fo50MHz45dB min fo100MHz
fo=1575.42MHz
Output V.S.W.R 2.0 maxInput Voltage DC = 3.00.5V
Current DC = 8mA at 3V
-
8/8/2019 GG2 Antenna Module Specification_A-Rev1
4/12
Tolerances (Unless otherwise specified)X : X.X : X.XX : Angle : Hole Dia. :
Unictron Technologies CorporationWebsite:www.unictron.com
Scale : Unit mm
Prepared By :Andy Checked By :Joe
Designed By :Hsin Approved By :Jaixing
THIS SPECIFICATION IS THE PROPERTY OF UNICTRONTECHNOLOGIES CORPORATION AND SHALL NOT BE REPRODUCEDOR USED IN ALL CIRCUMSTANCES WITHOUT WRITTEN PERMISSION
DOCUMENT REV.TITLE GG2 Active Antenna EngineeringSpecification NO.
9019GG21129900002A
PAGE 4 OF 12
7. Block Diagram:
8 . Measurement Method:Patch:
a). Reflection Coefficient Measurement
Equipment : Network Analyzer (Agilent E5071A)(Fig.1)
Item : S 11 Log Chart (Return loss) S 11 Smith Chart (Impedance)
Fig.1 Network Analyzer
b). Pattern Measurement
Equipment : Anechoic Chamber (Fig.2), Network Analyzer (Agilent E8753ES),
Standard Horn
-
8/8/2019 GG2 Antenna Module Specification_A-Rev1
5/12
-
8/8/2019 GG2 Antenna Module Specification_A-Rev1
6/12
Tolerances (Unless otherwise specified)X : X.X : X.XX : Angle : Hole Dia. :
Unictron Technologies CorporationWebsite:www.unictron.com
Scale : Unit mm
Prepared By :Andy Checked By :Joe
Designed By :Hsin Approved By :Jaixing
THIS SPECIFICATION IS THE PROPERTY OF UNICTRONTECHNOLOGIES CORPORATION AND SHALL NOT BE REPRODUCEDOR USED IN ALL CIRCUMSTANCES WITHOUT WRITTEN PERMISSION
DOCUMENT REV.TITLE GG2 Active Antenna EngineeringSpecification NO.
9019GG21129900002A
PAGE 6 OF 12
LNA:
a). Parameter Measurement
Equipment : Network Analyzer (Agilent E5071B)(Fig.4)
Item : S 11 , S 12 , S 21 , S 2
Fig.4 Network Analyzer
b). Noise Figure Measurement
Equipment : Noise meter (Agilent E4407B-219)(Fig.5)
Environment: Shielding Room (Fig.6)
Item :N.F (Noise Figure)
Fig.5 Noise Meter Fig.6 Shielding Room
-
8/8/2019 GG2 Antenna Module Specification_A-Rev1
7/12
Tolerances (Unless otherwise specified)X : X.X : X.XX : Angle : Hole Dia. :
Unictron Technologies CorporationWebsite:www.unictron.com
Scale : Unit mm
Prepared By :Andy Checked By :Joe
Designed By :Hsin Approved By :Jaixing
THIS SPECIFICATION IS THE PROPERTY OF UNICTRONTECHNOLOGIES CORPORATION AND SHALL NOT BE REPRODUCEDOR USED IN ALL CIRCUMSTANCES WITHOUT WRITTEN PERMISSION
DOCUMENT REV.TITLE GG2 Active Antenna EngineeringSpecification NO.
9019GG21129900002A
PAGE 7 OF 12
9 . Antenna Dimensions:
Tolerance (unless otherwise specified): X.X=+/-0.1 unit: mm
-
8/8/2019 GG2 Antenna Module Specification_A-Rev1
8/12
Tolerances (Unless otherwise specified)X : X.X : X.XX : Angle : Hole Dia. :
Unictron Technologies CorporationWebsite:www.unictron.com
Scale : Unit mm
Prepared By :Andy Checked By :Joe
Designed By :Hsin Approved By :Jaixing
THIS SPECIFICATION IS THE PROPERTY OF UNICTRONTECHNOLOGIES CORPORATION AND SHALL NOT BE REPRODUCEDOR USED IN ALL CIRCUMSTANCES WITHOUT WRITTEN PERMISSION
DOCUMENT REV.TITLE GG2 Active Antenna EngineeringSpecification NO.
9019GG21129900002A
PAGE 8 OF 12
10 . Measured Value:Patch:a). Radiation Gain Pattern (exclude LNA Gain from GG2):
0345
330
315
300
285
270
255
240
225
210
195180
165
150
135
120
105
90
75
60
45
30
15
-30 -20 -10 0 dB
Far-field amplitude of 1606040207 H-plane & E-plane.nsi
1606040207 1606040207_E
H-plane E-plane
PS: Total Gain = Radiation Pattern (exclude LNA Gain from GG2) + LNA Gain - cable loss (1.1dB/m)
ZZZZ
XXXX,90,90,90,90
Y,Y,Y,Y,0000
ZZZZ
XXXX,90,90,90,90
Y,Y,Y,Y,0000
-
8/8/2019 GG2 Antenna Module Specification_A-Rev1
9/12
Tolerances (Unless otherwise specified)X : X.X : X.XX : Angle : Hole Dia. :
Unictron Technologies CorporationWebsite:www.unictron.com
Scale : Unit mm
Prepared By :Andy Checked By :Joe
Designed By :Hsin Approved By :Jaixing
THIS SPECIFICATION IS THE PROPERTY OF UNICTRONTECHNOLOGIES CORPORATION AND SHALL NOT BE REPRODUCEDOR USED IN ALL CIRCUMSTANCES WITHOUT WRITTEN PERMISSION
DOCUMENT REV.TITLE GG2 Active Antenna EngineeringSpecification NO.
9019GG21129900002A
PAGE 9 OF 12
b). S 11 Smith Chart (Impedance):
c). S 11 Log Chart (Return loss): Bandwidth (S11
-
8/8/2019 GG2 Antenna Module Specification_A-Rev1
10/12
Tolerances (Unless otherwise specified)X : X.X : X.XX : Angle : Hole Dia. :
Unictron Technologies CorporationWebsite:www.unictron.com
Scale : Unit mm
Prepared By :Andy Checked By :Joe
Designed By :Hsin Approved By :Jaixing
THIS SPECIFICATION IS THE PROPERTY OF UNICTRONTECHNOLOGIES CORPORATION AND SHALL NOT BE REPRODUCEDOR USED IN ALL CIRCUMSTANCES WITHOUT WRITTEN PERMISSION
DOCUMENT REV.TITLE GG2 Active Antenna EngineeringSpecification NO.
9019GG21129900002A
PAGE 10 OF 12
Low noise amplifier (LNA): a). S11: (network analyzer input power -40dBm)
b).S12: (network analyzer input power is -40dBm)
-
8/8/2019 GG2 Antenna Module Specification_A-Rev1
11/12
Tolerances (Unless otherwise specified)X : X.X : X.XX : Angle : Hole Dia. :
Unictron Technologies CorporationWebsite:www.unictron.com
Scale : Unit mm
Prepared By :Andy Checked By :Joe
Designed By :Hsin Approved By :Jaixing
THIS SPECIFICATION IS THE PROPERTY OF UNICTRONTECHNOLOGIES CORPORATION AND SHALL NOT BE REPRODUCEDOR USED IN ALL CIRCUMSTANCES WITHOUT WRITTEN PERMISSION
DOCUMENT REV.TITLE GG2 Active Antenna EngineeringSpecification NO.
9019GG21129900002A
PAGE 11 OF 12
c). S21 (Gain): (network analyzer input power is -40dBm)
d). S22 (Gain): (network analyzer input power is -40dBm)
-
8/8/2019 GG2 Antenna Module Specification_A-Rev1
12/12
Tolerances (Unless otherwise specified)X : X.X : X.XX : Angle : Hole Dia. :
Unictron Technologies CorporationWebsite:www.unictron.com
Scale : Unit mm
Prepared By :Andy Checked By :Joe
Designed By :Hsin Approved By :Jaixing
THIS SPECIFICATION IS THE PROPERTY OF UNICTRONTECHNOLOGIES CORPORATION AND SHALL NOT BE REPRODUCEDOR USED IN ALL CIRCUMSTANCES WITHOUT WRITTEN PERMISSION
DOCUMENT REV.TITLE GG2 Active Antenna EngineeringSpecification NO.
9019GG21129900002A
e). N.F. (Noise Figure):