Fluid Flow Part 1
-
Upload
tusharan-mohan -
Category
Documents
-
view
32 -
download
4
description
Transcript of Fluid Flow Part 1
![Page 1: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/1.jpg)
Dr. Mohammed Abdalla Ayoub
![Page 2: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/2.jpg)
Lesson Outcomes
To explain the primary reservoir characteristics.
To describe the linear and radial flow behavior of the reservoir fluids in porous media.
To understand the mathematical relationships that are designed to describe the flow behavior of the reservoir fluids in porous media.
![Page 3: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/3.jpg)
Introduction
Flow in porous media is a very complex phenomenon and as such cannot be described as explicitly as flow through pipes or conduits.
Measure the length and diameter of a pipe and compute its flow capacity as a function of pressure; in porous media, however, flow is different in that there are no clear-cut flow paths which lend themselves to measurement.
![Page 4: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/4.jpg)
Objective
To present the mathematical relationships that are designed to describe the flow behavior of the reservoir fluids. The mathematical forms of these relationships will vary depending upon the characteristics of the reservoir.
The primary reservoir characteristics that must be considered include:
![Page 5: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/5.jpg)
Types of fluids in the reservoir
Flow regimes
Reservoir geometry
Number of flowing fluids in the reservoir
![Page 6: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/6.jpg)
Types of fluids
The isothermal compressibility coefficient is essentially the controlling factor in identifying the type of the reservoir fluid. In general, reservoir fluids are classified into three groups:
Incompressible fluids
Slightly compressible fluids
Compressible fluids
![Page 7: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/7.jpg)
the isothermal compressibility coefficient c is described mathematically by the following two equivalent expressions:
In terms of fluid volume:
-------------- (1)
![Page 8: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/8.jpg)
In terms of fluid density:
-------------- (2)
where V and ρ are the volume and density of the fluid, respectively.
![Page 9: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/9.jpg)
Incompressible fluids
An incompressible fluid is defined as the fluid whose volume (or density) does not change with pressure, i.e.:
![Page 10: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/10.jpg)
Slightly compressible fluids These “slightly” compressible fluids exhibit small
changes in volume, or density, with changes in pressure.
The changes in the volumetric behavior of this fluid as a function of pressure p can be mathematically described by integrating Equation (1) to give:
![Page 11: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/11.jpg)
where;
p = pressure, psia
V = volume at pressure p, ft3
pref = initial (reference) pressure, psia
Vref = fluid volume at initial (reference) pressure, ft3
-------------- (3)
![Page 12: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/12.jpg)
The ex may be represented by a series expansion as:
Because the exponent x [which represents the term c (pref−p)] is very small, the ex term can be approximated by truncating Equation (4) to:
-------------- (4)
-------------- (5)
![Page 13: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/13.jpg)
Combining Equation (5) with Equation (3) gives:
A similar derivation is applied to Equation (2) to give:
-------------- (6)
-------------- (7)
where V = volume at pressure p
ρ = density at pressure p
Vref = volume at initial (reference) pressure pref
ρref = density at initial (reference) pressure pref
![Page 14: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/14.jpg)
Compressible Fluids
These are fluids that experience large changes in volume as a function of pressure
All gases are considered compressible fluids.
The truncation of the series expansion, as given by Equation (5), is not valid in this category and the complete expansion as given by Equation (4) is used.
![Page 15: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/15.jpg)
the isothermal compressibility of any compressible fluid is described by the following expression:
Figures (1) and (2) show schematic illustrations of the volume and density changes as a function of pressure for the three types of fluids:
-------------- (8)
![Page 16: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/16.jpg)
Figure(1)
Pressure-volume relationship
![Page 17: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/17.jpg)
Figure(2)
Fluid density versus pressure for different fluid types
![Page 18: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/18.jpg)
FLOW REGIMES
There are basically three types of flow regimes that must be recognized in order to describe the fluid flow behavior and reservoir pressure distribution as a function of time:
Steady-state flow
Unsteady-state flow
Pseudosteady-state flow
![Page 19: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/19.jpg)
Steady-State Flow
• The pressure at every location in the reservoir
remains constant does not change with time
-------------- (9)
![Page 20: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/20.jpg)
In reservoirs, the steady-state flow condition can only occur when the reservoir is completely recharged and supported by strong aquifer or pressure maintenance operations.
![Page 21: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/21.jpg)
Unsteady / Transient State Flow The fluid flowing condition at which the rate of
change of pressure with respect to time at any position in the reservoir is not zero or constant
The pressure derivative with respect to time is essentially a function of both position i and time t
-------------- (10)
![Page 22: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/22.jpg)
Pseudosteady-State Flow
The pressure at different locations in the reservoir is declining linearly as a function of time
-------------- (11)
![Page 23: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/23.jpg)
Figure (3)
Flow regimes
![Page 24: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/24.jpg)
RESERVOIR GEOMETRY
The shape of a reservoir has a significant effect on its flow behavior
Most reservoirs have irregular boundaries
Rigorous mathematical description of geometry is often possible only with the use of numerical simulators
The actual flow geometry may be represented by one of the following flow geometries:
![Page 25: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/25.jpg)
Radial flow
Linear flow
Spherical and hemispherical flow
![Page 26: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/26.jpg)
Radial Flow
Flow into or away from a wellbore will follow radial flow lines from a substantial distance from the wellbore
In the absence of severe reservoir heterogeneities
fluids move toward the well from all directions and coverage at the wellbore
![Page 27: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/27.jpg)
Figure (4)
Ideal radial flow into a wellbore.
![Page 28: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/28.jpg)
Linear Flow
When flow paths are parallel and the fluid flows in a single direction
The cross sectional area to flow must be constant
A common application of linear flow equations is the fluid flow into vertical hydraulic fractures
![Page 29: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/29.jpg)
Figure (5)
Linear flow
![Page 30: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/30.jpg)
Figure (6)
Ideal linear flow into vertical fracture
![Page 31: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/31.jpg)
Spherical and Hemispherical Flow
Depending upon the type of wellbore completion configuration
possible to have a spherical or hemispherical flow near the wellbore
A well with a limited perforated interval could result in spherical flow in the vicinity of the perforations
A well that only partially penetrates the pay zone could result in hemispherical flow
![Page 32: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/32.jpg)
Figure (7)
Spherical flow due to limited entry
![Page 33: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/33.jpg)
Figure (8)
Hemispherical flow in a partially penetrating well
![Page 34: Fluid Flow Part 1](https://reader034.fdocuments.net/reader034/viewer/2022042514/563dbb0f550346aa9aa9ee20/html5/thumbnails/34.jpg)
NUMBER OF FLOWING FLUIDS IN THE RESERVOIR
Single-phase flow (oil, water, or gas)
Two-phase flow (oil-water, oil-gas, or gas-water)
Three-phase flow (oil, water, and gas)