Externally AdjustableDay&Night IR-LED

Vari-focal Bullet Camera

LED 42pcs:

LED 60pcs:

1/3” Sony Super HAD II High-Resolution Color CCD

Lens spec.

Externally Adjustable Focal Length & Focus

Color & B/W Auto Switchable by Photocell

Auto Switching IR-LED Control

- IR LED: 42pcs, 60pcs

Built-in DC Iris level adjustable volume

Built-in Service monitor port

Cable managed bracket

Weatherproof Housing(IP-66)

Power: AC24V/DC12V or DC12V

Standard

Option

42 LEDs2.8~11mm Vari-focal, DC Auto Iris F1.2 Day&Night Lens

3.8~9.5mm F1.29.0~22mm F1.4

6~50mm F1.4

60 LEDs

LED:60pcs

Ø

Ø

LED:42pcs

153

169

144

88102

128.78877.5

1. PROTECTIVE FILM2. FOCUS / ZOOM LEVER BOLT SCREW3. FOCUS / ZOOM RING FIXING SCREW4. FOCUS / ZOOM RING5. DC LEVEL VOLUME SCREW CAP

6. SERVICE VIDEO PORT7. MOUNTING BRACKET8. VIDEO / POWER CABLE 9. SUN-SHIELD

(THE OTHER SIDE SCREWS)

9

8

1 7

6

5

f=3.8~9.5mmf=2.8~11mm

f=6.0~50mm

f=9.0~22mm

4

2

SERVICE VIDEOPORT CAP

3

1. Protective Film Remove this film before operating the camera.

2. Focus / Zoom Lever Bolt Screw To fix the Focus / Zoom Ring to the lens internally.

3. Focus / Zoom Ring Fixing Screw To fix the Focus / Zoom Ring at the desired position after adjusting the lens viewing angle and focus setting as described below.

4. Focus / Zoom Ring These two rings are used to accurately adjust the viewing angle and to sharply focus all objects within the lens field of view.

① Loosen the fixing screws of the Zoom / Focus Ring: To widen the viewing angle turn the “Zoom Ring” to “W” (Wide), to obtain a closer view turn it to “T” (Tele).

② After adjusting the viewing angle adjust the “Focus Ring” to “N” (Near) or “∞” (Far) until the sharpest focus is achieved.

③ Then tighten the fixing screws on each ring.

Parts Description

Be careful not to loosen the Focus / Zoom lever boltscrews which should not be touched in normal use.

It could be caused by water entering to the cameraunless tightened the Focus / Zoom Ring Fixing screw.

6. Service Video Port - As service monitor port, open the service video port cap to connect the service monitor cable and the monitor - Check a picture position through the service monitor and adjust a viewing angle and focus of the camera.

7. Mounting Bracket (Cable Managed Type) - Install the Mounting Bracket at the desired location. Using four supplied screws fix it to wall. - Adjust pan & tilt of the camera with the supplied wrench.

8. Video / Power Cable

9. Sun-Shield - After adjustments, cover the sun-shield on the camera body then tighten it with the sun-shield bolt.

Parts Description

5. DC Level Volume Screw Cap ① Remove the screw cap with the supplied driver. Retain it in a safe place as it must be replaced to protect the camera from water entering. ② Beneath the screw is the DC Level Volume (Port). - For a brighter screen turn the Volume slowly towards “H”(counter- clockwise), for a darker screen turn it towards “L” (clockwise) with a small (+) driver. ③ Screw the Cap back and tighten to protect water entering.

9

SERVICE MONITOR PORT

SERVICE MONITOR CABLE

VIDEO(BNC) OUT

All camera models are supplied with second video output on the camera model. To use this feature along with a service monitor, service monitor cable/connector is reqired.

To avoid fire or shock hazard, must use a UL listed power supply. Check the impedance switch when the screen turns blurred.

10

■ Adjusting Camera View

PAN: Adjusting view directions

ROTATION: Adjusting screen view

TILT: Adjusting view angle

Adjustments

Max. 90% RH

MAX: 620mA/DC12V, 12VA/AC24V

MAX: 1A/DC12V, 18VA/AC24V

ATW

VBS 1.0 Vp-p (75Ω Load)

0Lux (IR LED On)

Internal

More than 48dB (AGC Off)

15.625KHz (H), 50Hz (V)

625 Lines 2:1 Interlace

ITEM

77.5mm (Ø 128.7mm (L)) ×

88mm ( 144mm (L)) Ø ×

-10℃ ~ +50℃-

AC24V/DC12V±10%, DC12V±10%± ±

1/50 sec1/60 sec

550TVL(Color), 580TVL(B/W)

15.734KHz (H), 59.94Hz (V)

525 Lines 2:1 Interlace

752H × 582V (440K pixels)×768H × 494V (380K pixels) ×

1/3" Interline transfer type color CCD (Sony)

Dimensions

Operational Humidity

Operating Temp.

Power Consumption

Power Supply(*)

Lens

Video Output

White Balance

Min. IlluminationSync. System

S/N Ratio

Shutter Speed

Resolution

Scanning Frequency

Scanning System

Effective Pixels

Image Sensor

PALNTSC ITEM

Standard

Option

42 LEDs2.8~11mm Vari-focal, DC Auto Iris F1.2 D/N Lens

3.8~9.5mm F1.29.0~22mm F1.4 6~50mm F1.4

60 LEDs

LED 42 pcs

LED 60 pcs

LED 42 pcs

LED 60 pcs

11

(*) Use regulated & specified power supply.

Externally Adjustable Day & Night IR-LEDVari-focal Bullet Camera

Rev.1