ERO Joint SK Assembly
2
Assembly round and V-belt ERO Joint® SK (Self Knot) (patent pending) Cut much longer than the required length (around 120 mm). Then strip each end to recover the traction cord (the sheath must have the required length -10 mm).
Transcript of ERO Joint SK Assembly
Assembly round and V-belt ERO Joint® SK (Self Knot)
(patent pending)
Cut much longer than the required length (around 120 mm).
Then strip each end to recover the traction cord (the sheath must have the required length -10 mm).
Take the both ends. Make a first knot.
Eventually add a point of speed glue to seal it. Then make a second knot in the opposite direction of the previous knot (see sketch).
Cut the dangle strands (in case the welding of the belt is necessary, continue reading).
Push the knot in a hollow of the belt.
Use the Multi TC and the U spare paddle to weld the belt.
Deburr using cutting pliers.
5 place des Alliés – 68290 MASEVAUX – Tél. 00.33.3.89.38.05.38 – Fax 00.33.3.89.82.49.11 www.tanals.com – [email protected]
Discover all ERO Joint® solutions : www.ero-joint.com
