----------------------- Page 1-----------------------Raw sketch version Rose - low intermediate model - diagram 8.11.11 - Evi Binzinger/Germany - www.kunstkauz.de Paper, which holds the crease well, is recommended. Foiled paper, wetfolded paper and duo colored papers are suitable. Diagrams for private usage only! 1 White side up. 2 Pre-crease diagonal 3 Pre-crease valley 4 Pre-crease valley 5 Pre-crease blintz 6 Collapse to windmill Pre-crease valley valley folds. folds. Turn over. folds to crease line. folds. Turn over. base. 7 Windmill (enlarged) folds. Sharp crease. 1 2 8 Align inner edges to 9 Blintz fold 10 Valley fold first the 11 Squash fold the upper 12 Open model again to 13 Pre-curve wings with a outer edges. Flatten paper. and open again. left, then the right side corner to the middle, while step 10, rotate the model folding bone (colored parts). to the middle. opening the right pocket and repeat step 11 and 12 Blintz fold and then push and mountain folding it to on all remaining sides. each wing into the NEXT the right side. Open again. pocket as far as possible. The model becomes 3D. Meaning of symbols 15 Finish the rose by molding and curving the edges. Valley fold Crease Press down four corners in the 14 Make a sharp valley Mountain fold Turn model fold, while flattening center to get a nicely filled rose. Mountain fold Press/push here the paper inside the corner. Only the right Mountain fold and open Fold half of the distance upper layer is lifted Valley fold Rotate model to the right side. Repeat on other corners. Valley fold and open Repeat step Open