Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.
-
Upload
adam-keith -
Category
Documents
-
view
220 -
download
2
Transcript of Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.
![Page 1: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/1.jpg)
Chemistry Qtr 3 Review GuideStoichiometry of Chemical Reactions
GasesSolutions
Acid and Bases
![Page 2: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/2.jpg)
Released Question 1A mass of 6.0 grams of Carbon disulfide reacts
with an excess of Chlorine gas, as shown in the unbalanced equation below:
CS2 + Cl2 - CCl4 + S2Cl2
Approximately, what mass of carbon tetrachloride is produced?
A 3 g C 76 g B 12 g D 152 g
![Page 3: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/3.jpg)
Equation is balanced 1st!
The unknown and given is written underneath equation.
The formula or molecular weights are calculated for both unknown and given.
Substances not involved in the problem are crossed out!
Problem is solved!
![Page 4: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/4.jpg)
When solving stoichiometry problems involving chemical reactions…
1. Check if the equation is balanced or unbalanced. If not, balance it!
2. Write the given and unknown underneath the balanced equation and cross out all reactants and products NOT involved in the problem.
3. Derive the mole-to-mole relationship between the given and unknown by using the coefficients in the balanced equation.
4. Solve!
![Page 5: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/5.jpg)
Released Question 2The set up shown below was used to describe the
atmospheric pressure at sea level:How might this same set up look like when taken to lower altitudes?A Height “h” will be shorter.B Height “h” will be longer.C Height “h” will be remain the same.D Height “h” will equal to 0.
![Page 6: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/6.jpg)
Pressure…Defined as Force per Unit Area. The SI unit for pressure is the Pa (Pascal)
which is equivalent to 1 Newton of force acting on one square meter.
Since gas particles are constantly in motion, they bump into each other and against the walls of the container this creates pressure.
Other units: 1 atm = 760 mmHg = 101, 325 Pa
![Page 7: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/7.jpg)
Released Test Question 3At room temperature, which of the
following gases would have the fastest rate of diffusion?
A Nitrogen B XenonC HeliumD Oxygen
![Page 8: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/8.jpg)
Diffusion of gases…
• Occur spontaneously as gas particles are in constant motion.
• Can be described by stating its rate or how ‘fast’ the particles move randomly.
• NET movement is from areas of high pressure to areas of low pressure.
• Molecular weight affects diffusion rate. Heavier molecules diffuse slower.
![Page 9: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/9.jpg)
Study the graph below:Which law is being illustrated?
A Charles’ LawB Gay-Lussac’s LawC Boyle’s LawD Avogadro’s Law
Released Test Question 3
![Page 10: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/10.jpg)
About gases…• Charles’ Law:
describes the relationship between the volume of a gas and how it relates to temperature
• Boyles’ Law: describes the relationship between the volume of a gas and how it relates to pressure.
![Page 11: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/11.jpg)
Released Test Question 4Gas Temperature Pressure 1 0oC 1 atm 2 273oK 600 mmHg 3 0oK 1 atm
4 100oC 600 mmHgWhich of the four gases above is at STP?A) 1 C) 3B) 2 D) 4
![Page 12: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/12.jpg)
• Any 1-mole sample of a gas, will occupy a volume of 22.4 L, at STP.
• What is STP? Standard Temperature and Pressure (conditions defined by a temperature of 0oC and 1 atm of pressure).
• An ‘ideal gas’ is a gas that behaves as describes by all the gas laws. The ideal gas constant is 0.0821 L-atm/oK-mol
About gases…
![Page 13: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/13.jpg)
Released Question 5The boiling point of methanol is 64.7 °C. The
boiling point of methanol on the Kelvin scale is approximately —
A.-100 KB. 148.4 K C. 337.8 KD. 446 K
![Page 14: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/14.jpg)
Released Question No. 6Gas A Gas B Gas C Gas D32.0 g 4.0 g 70.9 g 83.8 g
All four gases described above occupy a volume of 22.4 L at STP. Gas A is most likely...
A N2
B He C O2
D Kr
![Page 15: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/15.jpg)
Released Question No. 7A student was assigned to take water samples
from a lake near his home. He measured the pH of one of the water samples to be 7.5. Which of the following best describes this sample of water?
A highly acidicB highly basicC slightly acidicD slightly basic
![Page 16: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/16.jpg)
Acids and BasesDefinitions-1) Bronsted-Lowry Acid: any substance that can
donate a hydrogen ion (proton). 2) Bronsted-Lowry Base: any substance that can
accept a hydrogen ion (proton).
![Page 17: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/17.jpg)
Released Question No. 8Consider this chemical equation:
In this reaction, why is the ammonia considered a base?A NH3 increases the hydronium ion concentration.
B NH3 decreases the hydroxide ion concentration.
C NH3 accepts a proton.
D NH3 donates a proton.
![Page 18: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/18.jpg)
Solutions…• Components of Solution- a. Solvent: present in greatest quantity
b. Solute: all other substances dissolved in the solvent.
• Equilibrium: Soluteundissolved Solutedissolved
• Ions dissolved in polar solvents are ‘hydrated’; they more around the solution surrounded by water molecules.
![Page 19: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/19.jpg)
Molarity of Solution• refers to the number of moles of solute
present per liter of solution.
![Page 20: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/20.jpg)
Released Question No. 10What is the molarity of a solution of
HNO3 if 2 liters of the solution contains 80 g of HNO3?
A 0.5 MB 0.63 MC 1 MD 4 M
![Page 21: Chemistry Qtr 3 Review Guide Stoichiometry of Chemical Reactions Gases Solutions Acid and Bases.](https://reader036.fdocuments.net/reader036/viewer/2022062417/5515503555034673228b644e/html5/thumbnails/21.jpg)
Step 1. We need moles for the Molarity Formula- so start by converting gHNO3 to moles.
Step 2. Use the Molarity Formula to calculate molarity. Plug “grams” HNO3.