Apple MacBook Pro RAM Installation 13” Models released · PDF fileApple MacBook Pro RAM...
Transcript of Apple MacBook Pro RAM Installation 13” Models released · PDF fileApple MacBook Pro RAM...
Apple MacBook Pro RAM Installation 13” Models released Mid 2009, Mid 2010
15” Models released Mid 2009, Mid 2010, Early/Late 2011, Mid 2012
What do I need? Clear Workspace
New RAM Module(s) Screwdriver
To prevent potential damage from anti-static electricity, you should discharge yourself first.
This can be done by simply touching a grounded metal
object, such as a radiator.
Installation Process 1 – Make sure the MacBook is
completely shut down and
switched off. Disconnect any
cables.
2 – Turn your MacBook over and
remove the 10 screws that are
securing the bottom case.
Remember where each screw came
from.
3 – Pry the back of the case away
from the MacBook.
7 x 3mm
3 x 13.5mm
4 – To remove any existing RAM,
push the levers on the sides of the
module away from the module. The
module will pop out as an angle.
5 – To install the new module, align
the notch on the gold part of the
module with the notch in the slot.
Tilt the card and push the memory
firmly and evenly into the slot.
There will be an audible click when
the memory is seated correctly.
Do not worry which way the stickers
face, as this will differ.
To reassemble the MacBook,
reattach the back panel and replace
the 10 screws into their locations.
Turn the Mac back on. Everything
should be running smoothly and
quicker than before.
Email – [email protected]
Tel – 01903 692 214