Abstract Template for ECCOMAS Composites 2007...
2
Instructions to Prepare a Two Page Abstract for the 4 th International Conference of Engineering Against Failure – ICEAF IV First A. Author *,1 , Second B. Author † , Third C. Author † * Affiliation of First Author Address [email protected] † Affiliation of Second and Third Authors Address [email protected] ABSTRACT Authors are requested to submit an abstract of approximately 800 words (2 pages maximum ) by e-mail to [email protected] Abstracts should briefly outline the main features, results and conclusions as well as their general significance and contain relevant references. The Abstract will be reproduced as submitted and unchanged in the Book of Abstracts to be delivered at the Conference to all participants. The abstract has to be written in English with a Times New Roman 11 points font single spaced. Paragraphs should have 6 points of space both above and below. Within the limitation of two pages, figures or photographs can be included. A minimum resolution of 300 dpi for each figure/photograph is recommended. The caption of the figure should appear bellow the image as “Figure 1: The port of Skiathos, Greece.” See the example below. Tables can be added if required. Captions for tables should be positioned above the table, as per example below. 1 Corresponding author
Transcript of Abstract Template for ECCOMAS Composites 2007...
Instructions to Prepare a Two Page Abstract for the 4th International Conference of Engineering Against Failure – ICEAF IV
First A. Author*,1 , Second B. Author†, Third C. Author†
*Affiliation of First AuthorAddress
†Affiliation of Second and Third AuthorsAddress
ABSTRACT
Authors are requested to submit an abstract of approximately 800 words (2 pages maximum) by e-mail to [email protected]
Abstracts should briefly outline the main features, results and conclusions as well as their general significance and contain relevant references. The Abstract will be reproduced as submitted and unchanged in the Book of Abstracts to be delivered at the Conference to all participants.
The abstract has to be written in English with a Times New Roman 11 points font single spaced. Paragraphs should have 6 points of space both above and below. Within the limitation of two pages, figures or photographs can be included. A minimum resolution of 300 dpi for each figure/photograph is recommended. The caption of the figure should appear bellow the image as “Figure 1: The port of Skiathos, Greece.” See the example below. Tables can be added if required. Captions for tables should be positioned above the table, as per example below.
Figure 1: The port of Skiathos, Greece
If references are used in the abstract, please use the style described below.
The Abstract must contain the full name and full address of author/s. Papers can only be accepted on the understanding that they will be presented at the Congress.
1 Corresponding author
Abstract title: Presenter Name
Table 1: Number of hits on website
Internet Explorer FirefoxSeptember 2006 23 15October 2006 54 36November 2006 123 87
Submission of abstracts should be made no later than 30th November 2014. Any abstract submitted after this date will be ignored. The Local Organizing Committee will then notify the author by e-mail that the abstract was accepted for presentation in the Conference no later than 15th December 2014.
References
[1] T.J.R. Hughes, The Finite Element Method. Dover Publications, Mineola, New York, 1987.
[2] C.G. Dávila, P.P. Camanho, C.A. Rose, Failure criteria for FRP laminates. Journal of Composite Materials, 39, 323-345, 2005.
![Stress-oriented hydrogen-induced cracking (SOHIC) in H2S ...ltsm.mead.upatras.gr/lab/public/image/conference...571 recommended practice [1] while the assessment of hydrogen damage](https://static.fdocuments.net/doc/165x107/6020d052a1d52c293713dc2b/stress-oriented-hydrogen-induced-cracking-sohic-in-h2s-ltsmmead-571-recommended.jpg)
