10’x10’ Metal Garden Gazebo #450926 Current instructions at www.improvementscatalog.com 1-800-642-2112 Page 1 of 5

Thanks for shopping with Improvements

!

10’ x 10’ Metal Garden Gazebo Item #450926

To order, call

1-800-642-2112

West Chester, OH 45069

Made in China

0414

If you have questions regarding this product, call

1-800-642-2112 Mon.-Fri. 9:00-5:00 EST (Ohio)

and ask for our product specialists, or e-mail:

productspecialist@improvementscatalog.com

See many more products on the Internet!

www.ImprovementsCatalog.com

Note:

To extend the life of the canopies, remove them if the Gazebo will not be used for an extended period of time.

Warning: In high winds, remove the Large Canopy to avoid the Gazebo from being blown and causing damage or injury.

Mosquito Screen (not shown) is sold separately.

10’x10’ Metal Garden Gazebo #450926 Current instructions at www.improvementscatalog.com 1-800-642-2112 Page 2 of 5

Parts List:

Note:

Read these instructions carefully before assembling. It will help you become familiar with the parts and construction.

Wait to dispose of the packing material until assembly is complete and all parts and hardware are accounted for. Sometimes a hardware bag can be tricky to find.

Two people might be required for assembly. Assembly Tips

Find a clean, smooth area on which to work, such as a carpet, in order to avoid scratching the parts.

Lay out all parts and hardware on the floor or on a table in the order of their number or letter. This will familiarize you with the parts and also help you find a part when you’re ready to assemble it.

Usually there is a small sticker on the part with the designating letter or number that matches the letter or number in the instructions. If that sticker is missing, look at the drawing in the instruction parts list, and try to recognize the part by its shape or characteristics like holes or grooves.

We have provided both text and a drawing in each step, so using both will help the most.

Each step assembles only a few parts, so just take it one step at a time.

Corner Qty: 4 Side Qty: 4

Roof Qty: 3 Folding Roof Qty: 1

Connector Qty: 1 Clamp Qty: 8

Stake Qty: 8 Small Canopy Qty: 1

Large Canopy Qty: 8

10’x10’ Metal Garden Gazebo #450926 Current instructions at www.improvementscatalog.com 1-800-642-2112 Page 3 of 5

Step 1: Notice the pin on the ends of the Sides (B). Fit the pin into the hole on the Corners (A) as shown below

Fit a Clamp (F) over both parts as shown below.

Step 2: Repeat with the other Sides and Corners until a square is formed.

10’x10’ Metal Garden Gazebo #450926 Current instructions at www.improvementscatalog.com 1-800-642-2112 Page 4 of 5

Step 3: Push the spring pins on the end of each Rib (D) and insert them into the arms of the Connector (E).

Step 3: Here’s where you’ll probably need someone to help you. Lift the Rib assembly from Step 2 and set it on the structure from Step 2.

Fit the short tubes on the Ribs over the short tubes on the Corners - press the pin on the short tube on the Corners so it snaps into the hole on the Rib short tubes.

Pin

10’x10’ Metal Garden Gazebo #450926 Current instructions at www.improvementscatalog.com 1-800-642-2112 Page 5 of 5

Step 4: Set the Small Canopy (H) over the Connector and straight sections of the Ribs.

Set the Large Canopy (I) over the Rib and stretch three of the corners around the outer ends of the Ribs.

Since it is a tight fit to get the fourth corner on the Rib, press the spring button near the end of the Pivoting Rib, and swing the end upward. Fit the last corner of the Large Canopy over the end, and swing it down until it snaps in place.

Step 5: Use the Stakes (G) to secure the Corners to the ground.