Prepared byM.Ganesh Murugan

9715447621

• Do not wear loose fitting garments as they can easily get caught in a moving part of the machine

• Wear prescribed uniform and shoes

• Long and unruly hair is dangerous particularly while working near the revolving parts of the machine

• Never wear a ring, bracelet or a watch while working, as they may be caught in a moving part injure you or it may even drag your finger or hand into the machine

• Wear approved safety goggles or face shields particularly when you are working on a job which produces flying chips or sparks

• Use personal protection equipment and safety devices as required

• Do not play with swarf. The hot sharp chips may burn or injure your hand

• Never run inside a workshop

• While walking watch your stepso Do not walk or work under suspended loads

• Be watchful of blind corners. You may get caught in the wrong way

• Do not carry too many tools or instruments at a time

• Do not operate any machine until you are authorizedo Fully understand the operations, control and safety

aspects of the machine before operating

• Know how to stop the machine before you start it

• Ensure that all control of the machine are accessible to you

• Ensure that all safety guards are in position

• Do not meddle with the limit switches

• Keep the machine clean – don’t clean it with bare hands. Use cloth, cotton waste or brush as per requirement

• Lubricate the machine as recommendedo Stop the machine while cleaning or oiling

• Do not operate the machine at unsafe speeds, feeds and depth of cuto Do not attempt to change the speed and feed when the

machine is in motion unless designed for it

• Do not try to set the machine, job or take measurements of job while the machine parts or job is in motion

• Do not lean on the machine

• Switch off the machine immediately if anything goes wrong

• Do not day dreamo Be alert and mind your job

• Be calm and patient while workingo A disturbed mind will invite trouble

• Do not divert the attention of others or do not get yourself diverted by others while workingo Over confidento It may even lead to major accidents

• Avoid horse playing/monkeyingo It is always dangerous

• Do not direct compressed air at your work mates or at your selfo It can kill

• Poor illumination

• Poor ventilation

• Poor house keeping

• Hazardous storage

• Congestion of material and equipmento Too narrow passages

• Material projection

• Unsafe equipment defects

• Inadequate or improper guardso Inadequate safety deviceso Inadequate warning system

• Hazardous atmospheric conditions

• Fire and explosion hazards

• Hazardous personal attire

• Golden rule No movement or minimum movement

• Be cautions to prevent cuts – while handling thin sheets and plates

• Wear gloves - while handling rough jobs

• Wear asbestos gloves - while handling hot material

• Don’t spill - while removing metal chips

• While handling materials take care to see that the limb are not caught or trapped

• Give proper padding to ropes to prevent sharp edges cutting the ropes while hoisting

• Balance the loado Don’t lift load too high or too low

• While handling long bars, keep the bars paralles to the passage

• Regularly check and maintain all material handling equipment

• Take proper care of all slinging gadgets like hooks, eye bolts, rods while using

• Ensure that the load carrying capacity is safe enough before using the equipment

• Plan to have a place for every tool, appliance and materials.o An orderly shop is less hazardous to work

• Pay attention to the maintenance of equipment.• Train employees to ensure the orderly and neatly.

o Develop a habit in employees to keep the manner.• Good house keeping is the personal responsibility of

every supervisor.o Every supervisor should be proud of making his section a

better place to work.• Cleanliness is next to godliness

o Ensure that floors and passages are clean and dry.A good house keeping and clean atmosphere makes employees

happy and promote a desire to turn out a quality job.

M.Ganesh Murugan9715447621