Transcript of Irrigation. MANDIBULAR CENTRAL INCISOR.
- Slide 1
- Irrigation
- Slide 2
- MANDIBULAR CENTRAL INCISOR
- Slide 3
- Slide 4
- Slide 5
- Slide 6
- Slide 7
- Slide 8
- Slide 9
- MANDIBULAR LATERAL INCISOR
- Slide 10
- Slide 11
- Slide 12
- MANDIBULAR CANINE
- Slide 13
- Slide 14
- MANDIBULAR FIRST PREMOLAR
- Slide 15
- Slide 16
- Slide 17
- Slide 18
- Slide 19
- MANDIBULAR SECOND PREMOLAR
- Slide 20
- Slide 21
- Slide 22
- Slide 23
- MANDIBULAR FIRST MOLAR
- Slide 24
- Slide 25
- Location of a second distal canal in the mandibular first
molar.
- Slide 26
- Slide 27
- Slide 28
- Slide 29
- The MB canal orifice typically exists directly beneath the MB
cusp tip, whereas the ML orifice is typically more centered on the
occlusal table.
- Slide 30
- Slide 31
- Slide 32
- Slide 33
- MANDIBULAR SECOND MOLAR
- Slide 34
- C-shaped canals
- Slide 35
- Slide 36
- Slide 37
- Slide 38
- Slide 39
- Slide 40
- Slide 41
- MANDIBULAR THIRD MOLAR
- Slide 42
- Slide 43
- Slide 44
- MAXILLARYMANDIBULAR INCISORS Ovoid or rounded triangular shape
Ovoid, 41.4 % have 2 canals CUSPIDS / CANINES Ovoid preparation
PREMOLARS Ovoid directed through middle of occlusal surface
Slightly round to oval extends towards buccal MOLARS Trapezoidal
form that connects MB, DB and P. 85-95 % MB 2 canals 85-95 % MB 2
canals Triangular form, if 2 D canals present then Trapezoidal
form
- Slide 45
- Slide 46
- Distance from the cusp tip to pulp chamber ceiling height is
approx : 6.0mm Distance from pulpal floor to the furcation is
approx : 3.0mm Average height of pulp chamber is : 1.5 -2.0mm The
pulp chamber ceiling was found at the level of the cementoenamel
junction in 97% - 98% of the maxillary and mandibular molars
MORPHOLOGICAL MEASUREMENTS OF ANATOMIC LANDMARKS IN MAXILLARY AND
MANDIBULAR MOLARS
- Slide 47
- Straight-line access should be established using Gates-Glidden
burs sizes 2-3 (and 4 in large canals). These instruments are only
intended for the coronal one third of the canal. They should be
applied with light sweeping motions about 3-5 times in and out of
the canal.
- Slide 48
- This is sodium hypochlorite in a concentration of either 5.25
or 2.5%. It acts as a medium to dissolve and flush organic debris
and bacterial products out of the root canal system, as well as
functioning as a lubricant and antibacterial agent. Irrigation
- Slide 49
- RC Prep contains 10% Urea peroxide, 15% EDTA (Ethyl di tetra
acetic acid) a chelating agent. When combined with sodium
hypochlorite, a chemical reaction takes place between the urea
peroxide and the sodium hypochlorite, to release nascent oxygen in
a bubbling action which aids in flushing debris out of the root
canal system. It is important that the root canal system is
irrigated after the use of each file size !
- Slide 50
- Slide 51
- Slide 52
- Slide 53
- Slide 54
- Slide 55
- Slide 56
- Slide 57
- Slide 58
- Slide 59
- Slide 60
- Slide 61
- Slide 62
- Slide 63
- STANDARDIZATION OF ENDODONTIC INSTRUMENTS
- Slide 64
- 16 mm D1 D16
- Slide 65
- Slide 66
- Slide 67
- The use of irrigating solutions is an important part of
effective chemomechanical preparation. Antibacterial agent. Tissue
solvent. Flush debris. Lubricant. Eliminate the smear layer.
- Slide 68
- Concentration of NaOCl. Berber et al. (2006)
- Slide 69
- The ability of an irrigant to be distributed to the apical
portion of a canal is dependent on: Canal anatomy Size of
instrumentation Delivery system Baumgartner & Cuenin
(1992)
- Slide 70
- Slide 71