H563 - Koala Kiosk Standfor iPad Pro 12.9-inch (3rd Gen)

For support, please contact Heckler.

service@hecklerdesign.com.

844-432-5930

2

IN THE BOX

Koala Kiosk Stand1 x

USB-C hub with USB-CCharge Cable and Audio Cable

1 x

Hex Assembly Key1 x

Torx Assembly Key1 x

Mounting Hardware2 x

Alcohol Pad2 x

CAT 6 Ethernet Cable1 x

3

COMPONENTS NEEDED(Not Included)

OPTIONAL COMPONENTS(Not Included)

TOOLS NEEDED(Not Included)

CAT 6, 6e, or 7 Ethernet Cable

Square Reader WiFi Texas GAT-USBC - POE+ Splitter for USB Type C

iPad Pro 12.9-inch (3rd Gen)Square Contactless Reader

Apple 18W USB-C Power Adapter

Included with your iPad Pro 12.9-inch (3rd Gen)

MicroUSB Cable for Square Contactless Reader

Apple USB-C Charging Cable Included with your iPad Pro 12.9-inch (3rd Gen)

Used when providing the kiosk power and data via Power-Over-Ethernet

3/4” Drill BitTape Measure Power DrillPen 1/4” Drill Bit

STEP 1

Remove back hatch.

4

STEP 2

Determine how to mount Kiosk Stand.

Without Base plate With Base plate

5

OR

Skip ahead to step 6

Use the Hex Assembly Key to remove two srews from base plate.

6

STEP 3

Disassemble base plate.

Drill two 1/4" holes and one 3/4" center hole

4.45

7

STEP 4

Drill mounting holes in table top.

4.45”

1”

2”

Table front edge

Table Top

8

STEP 5

Install mounting hardware.

STEP 6

Remove front bezel.

9

Make sure the iPad orientation is correct. The sleep/wake button should be positioned in the lower right corner. Route the USB-C cable as shown.

10

STEP 7

Install iPad Pro and connect USB-C cable.

The front bezel is asymmetric. Position the bezel as shown.

11

STEP 8

Reinstall front bezel.

12

STEP 9

Install Square Contactless Reader and route its Micro USB Cable.

1. Route the Micro USB Cable

2. Use Alcohol Pad to clean the bottom of Square Contactless Reader.

3. Adhere Square Contactless Reader to bracket.

4. Slide bracket in place, tighten thumb nut.

13

STEP 10

Connect cables to USB-C hub

USB Port

USB-C Port

Audio Port

14

STEP 11

Organize cables and USB-C Hub inside neck and reinstall back hatch.

15

STEP 12

Select your data and power solution.

Conventional AC Power and Networking

PoE+ Networking

Apple Power Adapter(USB-C)

Conventional Network Switch

PoE+ Network Switch

OR

WiFi Texas GAT-USBC - POE+ Splitter for USB Type C

PowerData