H563 - Koala Kiosk Stand€¦ · Included with your iPad Pro 12.9-inch (3rd Gen) Used when...
Transcript of H563 - Koala Kiosk Stand€¦ · Included with your iPad Pro 12.9-inch (3rd Gen) Used when...
H563 - Koala Kiosk Standfor iPad Pro 12.9-inch (3rd Gen)
For support, please contact Heckler.
844-432-5930
2
IN THE BOX
Koala Kiosk Stand1 x
USB-C hub with USB-CCharge Cable and Audio Cable
1 x
Hex Assembly Key1 x
Torx Assembly Key1 x
Mounting Hardware2 x
Alcohol Pad2 x
CAT 6 Ethernet Cable1 x
3
COMPONENTS NEEDED(Not Included)
OPTIONAL COMPONENTS(Not Included)
TOOLS NEEDED(Not Included)
CAT 6, 6e, or 7 Ethernet Cable
Square Reader WiFi Texas GAT-USBC - POE+ Splitter for USB Type C
iPad Pro 12.9-inch (3rd Gen)Square Contactless Reader
Apple 18W USB-C Power Adapter
Included with your iPad Pro 12.9-inch (3rd Gen)
MicroUSB Cable for Square Contactless Reader
Apple USB-C Charging Cable Included with your iPad Pro 12.9-inch (3rd Gen)
Used when providing the kiosk power and data via Power-Over-Ethernet
3/4” Drill BitTape Measure Power DrillPen 1/4” Drill Bit
STEP 1
Remove back hatch.
4
STEP 2
Determine how to mount Kiosk Stand.
Without Base plate With Base plate
5
OR
Skip ahead to step 6
Use the Hex Assembly Key to remove two srews from base plate.
6
STEP 3
Disassemble base plate.
Drill two 1/4" holes and one 3/4" center hole
4.45
7
STEP 4
Drill mounting holes in table top.
4.45”
1”
2”
Table front edge
Table Top
8
STEP 5
Install mounting hardware.
STEP 6
Remove front bezel.
9
Make sure the iPad orientation is correct. The sleep/wake button should be positioned in the lower right corner. Route the USB-C cable as shown.
10
STEP 7
Install iPad Pro and connect USB-C cable.
The front bezel is asymmetric. Position the bezel as shown.
11
STEP 8
Reinstall front bezel.
12
STEP 9
Install Square Contactless Reader and route its Micro USB Cable.
1. Route the Micro USB Cable
2. Use Alcohol Pad to clean the bottom of Square Contactless Reader.
3. Adhere Square Contactless Reader to bracket.
4. Slide bracket in place, tighten thumb nut.
13
STEP 10
Connect cables to USB-C hub
USB Port
USB-C Port
Audio Port
14
STEP 11
Organize cables and USB-C Hub inside neck and reinstall back hatch.
15
STEP 12
Select your data and power solution.
Conventional AC Power and Networking
PoE+ Networking
Apple Power Adapter(USB-C)
Conventional Network Switch
PoE+ Network Switch
OR
WiFi Texas GAT-USBC - POE+ Splitter for USB Type C
PowerData