Forming MachinesFoldable Information

FORGE

Related Terms

Anvil Blacksmith’s Hammer Ferrous Metals

FORGE

Uses

Used to heat up ferrous metal to a red hot temperature.

The metal can then be shaped using the anvil and blacksmith’s hammers.

FORGE

Safety Rules

Always make sure the lid is open before lighting.

Stay away from opening when lighting.

Always shut the gas and air off when shutting down the forge.

Be aware of where the hot metal is at all times.

CRUCIBLE FURNACE

Related Terms

Non-ferrous metals

Ingots

Oil Bonded Sand Casting

CRUCIBLE FURNACE

Use

Used to melt non-ferrous metal that will be cast into a mold.

CRUCIBLE FURNACE

Safety Rules Always have the lid open when lighting.

Always keep any moisture away from the molten metal.

Only instructor may fill the furnace or pour the molten metal.

Turn off the gas and the air when shutting down the furnace.

RING ROLLER

Related Terms

Sheet metal (slip rolls)

Round or square bar (ring roller)

RING ROLLER

Uses

Used to roll metal into a cylinder, cone or ring.

RING ROLLER

Safety Rules

Keep fingers away from moving parts.

Do not overload the machines with to thick of a material.

Increase amount of curve over several passes.