Page 1
SB-CMS-PIR - ceiling mounted PIR sensor
Page 2
Subnet ID and Device ID
Device Remark
Change the ID if needed
Page 3
e.g., you can enable/disable the PIR sensor in HDL-BUS Pro software, you can also send UV switch 253-ON to enable it, or send UV switch 253-OFF to disable it.
Page 4
Combine logic inputs
Select logic relation
Set logic output
better to set some delay time, e.g., 10s.
Page 5
Enable the security function of ch1
Assign ch1 to the security
module(3/80) and security
area (1).
Page 6
Simulate some sensor
value or status.
This is very useful when
to test the new-created
function.
Page 7
application
Please refer to the 12in1 sensor