Topic: Implant insertion after tooth extraction: Clinical outcomes with different approaches
Presented by Edith Groenendijk & Tristan Staas
References
Conclusion
Introduction
PROTOCOL FOR IMMEDIATE TOOTH REPLACEMENT IN THE ESTHETIC REGION
MINIMAL INVASIVE, MAXIMAL EFFECTIVE
Immediately placed front tooth implants 1 : Analysis with Cone Beam Computed
Tomography after remodelling of the buccal plate
Staas TA, Groenendijk E, Graauwmans FEJ, Verhamme L, Maal T, Meijer GJ
!
Abstract Results
Material & Method
The aim of this retrospective research was to study the stability of the buccal bone
using a protocol for immediate tooth replacement described by Staas & Groenendijk.
In the period 1 January 2008 to 1 January 2012, in 186 patients an implant was installed
immediately after the removal of a maxillary incisor. Subsequent to placement of the
implant, a 2 mm gap between implant and buccal plate was filled with a bone
substitute. In addition to a pre-operatively and per-operatively cone beam computer
tomogram (CBCT), also a late-postoperative cone beam computer tomogram was
produced in 16 cases. Per-operative, the buccal plate thickness increased by 1.5 mm
(mean) from 0.9 mm to 2.4 mm (mean). During the evaluation period of 1 to 4 years a
reduction took place resulting in a final buccal plate thickness of 1.8 mm on average.
Surprisingly, the buccal plate bone height increased by 1.6 mm (mean), to an average
of 1.2 mm above the implant shoulder. In these cases it was crucial that the implant
was placed in such a way that a gap of a minimum of 2.0 mm was created between the
original buccal plate and the implant, and that this gap was filled with a bone
substitute. With this minimal invasive treatment protocol, costs and treatment time
are minimized, while patient comfort and esthetics are optimized. Although the results
are promising, further research on this topic is necessary.
• Atieh MA, Payne AG, Duncan WJ, Cullinan MP. Immediate restoration/loading of immediately placed single implants: is it an effectivebimodal approach? Clin Oral Implants
Res 2009; 20: 645–659.
• Araújo M, Linder E, Wennström J, Lindhe J. The influence of Bio-Oss Collagen on healing of an extraction socket: an experimental studyin the dog. Int J Periodontics
Restorative Dent 2008; 28: 123-135.
• Becker W. Immediate implant placement: diagnosis, treatmentplanning and treatment steps/or successful outcomes. J Calif Dent Assoc 2005; 33: 303-310.
• Becker W. Immediate implant placement: treatment planning andsurgical steps for successful outcomes. Br Dent J 2006; 201: 199-205.
• Block MS, Mercante DE, Lirette D, Mohamed W, Ryser M, Castellon P. Prospective evaluation of immediate and delayed provisional single tooth restorations. J Oral
Maxillofac Surg 2009; 67: 89-107.
• Botticelli D, Berglundh T, Lindhe J. Hard-tissue alterations following immediate implant placement in extraction sites. J Clin Periodontol 2004; 31: 820-828.
• Chen ST, Darby IB, Reynolds EC. A prospective clinical study of non-submerged immediate implants: clinical outcomes and esthetic results. Clin Oral Implants Res 2007;
18: 552-562.
• Cooper LF, Raes F, Reside GJ, et al. Comparison of radiographic and clinical outcomes following immediate provisionalization of single-tooth dental implants placed in
healed alveolar ridges and extraction sockets.Int J Oral Maxillofac Implants 2010; 25: 1222-1232.
• Cordaro L, Torsello F, Roccuzzo M. Clinical outcome of submerged vs. non-submerged implants placed in fresh extraction sockets. Clin Oral Implants Res 2009; 20:1307-
1313.
• Ferrus J, Cecchinato D, Pjetursson EB, Lang NP, Sanz M, Lindhe J. Factors influencing ridge alterations following immediate implantplacement into extraction sockets. Clin
Oral Impl Res 2010; 21: 22–29.
• Huynh-Ba G, Pjetursson BE, Sanz M, et al. Analysis of the socket bone wall dimensions in the upper maxilla in relation to immediate implant placement. Clin Oral Implants
Res 2010; 21: 37-42.
• Miyamoto Y, Obama T. Dental cone beam computed tomography analyses of post-operative labial bone thickness in maxillary anterior implants: comparing immediate and
delayed implant placement.Int J Periodontics Restorative Dent 2011; 31: 215-225.
• Nevins M, Camelo M, De Paoli S, et al. A study of the fate of thebuccal wall of extraction sockets of teeth with prominent roots.Int J Periodontics Restorative Dent 2006; 26:
19-29.
• Quirynen M, Van Assche N, Botticelli D Berglundh T. How does the timing of implant placement to extraction affect outcome? Int J Oral Maxillofac Implants 2007; 22: 203-
223.
• Sanz M, Cecchinato D, Ferrus J, Pjetursson EB, Lang NP, Lindhe J. A prospective, randomized-controlled clinical trial to evaluate bone preservation using implants with
different geometry placed into extraction sockets in the maxilla. Clin Oral Implants Res 2010; 21: 13–21.
• Schwartz-Arad D, Chaushu G. The ways and wherefores of immediate placement of implants into fresh extraction sites: a literature review.J Periodontol 1997; 68: 915-923.
• Spin-Neto R, Stavropoulos A, Dias Pereira LA, Marcantonio E jr, Wenzel A. Fate of autologous and fresh-frozen allogeneic block bone grafts used for ridge augmentation. A
CBCT-based analysis. Clin Oral Implants Res 2013; 24: 167-173
In a period from 1 January 2008 to 1 January 2012 186 patients were treated with an
immediate implant to replace a lateral or central maxillary incisor. Patients were
treated by one practitioner. After some time another CBCT was indicated for diagnostic
reasons in 16 cases (4 men; 12 women). This made it possible to use this CBCT for late
postoperative evaluation. The ages of the 16 patients included ranged from 17 to 72
years with an average age of 44 years. A standard protocol described by Staas &
Groenendijk was followed in all patients. Using this protocol a pre-operative CBCT is
made for diagnostic reasons and planning of the implant treatment, while a per-
operative CBCT is made to capture the three dimensional position of the implant after
the flapless surgery. The pre-operative CBCT shows the natural tooth in situ or an
empty socket immediate after avulsion.
Two implants were at position 11, four at position 21, eight at position 12 and two at
position 22. In 9 cases persistent periapical pathology was reason for extraction, four
cases had a crown - or root fracture and three cases were found to a recent trauma
related avulsion. NobelActive ™ Internal implants were placed using the
manufacturers drill protocol: 1 X Ø 3.0 mm x length 13.0 mm; 4 X Ø 3.5 mm x length
13.0 mm; 6 X 3.5 Ø x length 15.0 mm; and 5 X Ø 4.3 mm x length 15.0 mm. In 15
patients Geistlich Bio-Oss ® was used as bone substitute with a grain size between
0.25-1.0 mm. The torque at immediate placement varied between 40 to 110 NCm with
an average of 65 NCm.
The time lag between implant placement and the manufacture of the late-postoperative
CBCT was between 43 and 202 weeks, with an average of 103 weeks after implant
placement. Based on ‘voxel-based alignment’ using software (version 2.3.0.3 Maxilim
®) the pre-operative, post-operative, and late-postoperative CBCT of each patient was
superimposed. As orientation the palate and the spina nasalis anterior was detained.
Three sagittal cuts were appointed; central of the placed implant (the mid-buccal cross
section), as well as 1 mm to the mesial and 1 mm to the distal. The width of the buccal
plate was measured 1 mm below the most coronal point . In this way the thickness of
the buccal plate was measured before implant placement, directly after and on average
103 weeks (range 43-202) after the surgery. By comparing the preoperative thickness,
the direct-postoperative thickness and late postoperative thickness the change in
buccal plate thickness was measured. The data were reviewed with a paired t-test. In
analogy of the bone thickness also the height of the buccal bone was determined in
the middle of the implant, 1 mm to the distal and 1 mm to the mesial. The difference in
bone-height can be described by reducing the late-postoperative height with the
preoperative height. For all provisions the mean and standard deviation and
dispersion were calculated. Differences were tested with a paired t-test and the
reliability, the duplo errors and structural measurement error were determined. A intra
reviewers-and inter-assessors check was carried out on the basis of repetition of all
measurements in 4 cases.
The success rate and esthetic outcome of implant treatment in the esthetic region
depends on multiple factors. In various studies on the topic of immediate replacement
key factors, such as the initial condition of the alveolar ridge before extraction,
surgical and prosthetic technique, surgical and prosthetic components and implant
position are either not well defined or not comparable to each other. Colleagues Staas
& Groenendijk defined a protocol for immediate tooth replacement in the esthetic
region. A retrospective research was performed in order to study the stability of the
buccal bone outcome using this protocol.
Per-operative, the buccal plate thickness increased by 1.5 mm (mean) from 0.9 mm to
2.4 mm (mean). During the evaluation period of 1 to 4 years a reduction took place
resulting in a final buccal plate thickness of 1.8 mm on average. The buccal plate bone
height increased by 1.6 mm (mean), to an average of 1.2 mm above the implant
shoulder. The observed increase in height ( ΔH values in the table) were at review
statistically significant (p < 0.001) on all measured cross sections. Both in thickness
(ΔD) as in height (ΔH) no differences were measured in the sagittal section created by
the mid-facial, 1 mm to the mesial and 1 mm to the distal.
With this minimal invasive treatment protocol, in which a gain in the buccal plate
thickness is seen of on average 1.5 mm and an increase in buccal bone height of on
average 1.6 mm in the mid-facial , costs and treatment time are minimized, while
patient comfort and esthetics are optimized. Although the results are promising,
further research on this topic is necessary.
Top Related