Manufacturing in Plastics
Thermoplastic Processes
© Ideas In2 Action 2006
Extrusion
The plastic is heated and when molten forced under pressure through a die
As the plastic leaves the die in its determined shape it is instantly cooled in water troughs and the hardened extrusion is either coiled or cut into sections
© Ideas In2 Action 2006
Extrusion (cont’d)
Thermoplastics such as PVC, and nylon are used in the extrusion process
© Ideas In2 Action 2006
EXTRUSION BLOW- MOULDING
The cycle1. A tube of plastic called
a parison is extruded into an open two-part mould
2. Mould closes to pinch the mould and air is blown into the tube forcing the plastic against the insides of the mould
3. The mould is opened to release the plastic shape and the cycle begins again.
© Ideas In2 Action 2006
EXTRUSION BLOW- MOULDING (cont’d)
Process for making bottles, milk containers, engine oil containers and hollow toys
PVC, Polythene and polypropylene are common blow moulding materials
© Ideas In2 Action 2006
Injection moulding
Making products by injecting molten plastic into a split mould
Polythene, polystyrene, polypropylene and nylon are typical injection moulding materials
© Ideas In2 Action 2006
Injection moulding (cont’d)
The cycle
1. Granules are fed into the heating barrel via a hopper whilst the die is also being warmed to 60 degrees. The die is empty at this stage
2. Molten plastic is injected into the mould to fill the cavity via a sprue. The die is water cooled to enable the plastic to harden in the mould
3. The component is the ejected and the cycle is repeated
© Ideas In2 Action 2006
Injection moulding (cont’d)
Portable power tool casings
Domestic powered utensils
Air fix model kits Vacuum cleaners Bottle caps Fixtures and snap
fittings
© Ideas In2 Action 2006
Vacuum forming cont’d
Polystyrene, ABS, acrylic and PVC are typical vacuum forming materials
© Ideas In2 Action 2006
Vacuum forming
Packaging –egg boxes, chocolate liners, point of sale packaging
Seed trays Shop signs and fittings Motor car dash boards
and bumpers Wash basins, shower
trays and baths
© Ideas In2 Action 2006
Rotational casting
Litter bins Traffic cones Liquid self-feeding
system for cattle Cooling and breather
pipes for car engines
© Ideas In2 Action 2006
Line bending
Jigs and formers are used to make accuratebends in the acrylic
© Ideas In2 Action 2006
Plastic coating
In industry the plastic powder and the component is electro statically charged
The powder is sprayed onto the component before entering a temperature controlled oven in the case of thermoplastics and a kiln in the case of enamel or thermosetting materials
(Note that this process is sometimes referred to as fluidizing)
© Ideas In2 Action 2006
Plug and yoke forming
Softened sheet plastic is sandwiched betweenA male and female mould and left to cool
© Ideas In2 Action 2006
Blow moulding
Top Related