Instructions for Collecting Pickleballs
Thank you for purchasing a Kollectaball! Our collectors work brilliantly with
Pickleballs however, it’s very important that they are assembled in a slightly
different manner to when collecting tennis balls.
The only difference is in the assembly of the wires; because Pickleballs are
lighter than most sports balls, it’s important you only assemble the cage with
half the wires. This will decrease the tension between the wires and allow the
Pickleballs to enter into the cage instead of being pushed further away when
collecting.
Please insert a wire in every other slot, as seen in the below pictures and
instructions. You will be left with 30 spare wires.
Step 1: Assemble
the handle as
explained in the
instructions that
come in the box.
Step 2: Insert a
wire in every other
slot. (Insert one
wire, miss a space
and then insert the
other).
Step 3: Continue
this until you have
completed the
sequence for the
first black plastic
disk.
If you make a mistake and place two wires side by side
as above, use the wire removal tool as shown. Push the
pin end of the tool into the hole corresponding with the
wire you would like to remove. Pull the wire out with
your spare hand.
Continue placing a wire in
every other hole until the
other black disk is
complete.
Take the other end of
the wires and begin
placing them into the
holes on the other black
plastic disk.
Take the orange cone and
place onto the available
screw
Use spanner provided to
tighten lock nut onto the
orange cone.
Lay down the rest the pieces on the
floor, you should have the handle, the
v-opener, the long screw, two flat
head screws, two washers and an M6
nut
Place the V-opener over
the handle so the holes
on either side of the v-
opener line up with the
holes on the handle
It should look like this
Placing a washer on either side,
thread the screw through the two
holes using the spanner provided.
It should now look like
this.
Now Screw the M6 nut
onto the end and tighten
Tighten the M6 nut with
the spanner provided.
Tighten the M6 nut with
the spanner provided.
*It’s worth retightening
both sides.
Push the bale into the
hole available at the end
of the handle.
Screw in the remaining
two flathead screws and
M6 nuts.
At the end of assembly you will be left with 30 wires. If you enjoy your
Kollectaball, please shout about us to your friends or on social media or review
our products on the sales channel you bought off!
Tighten the M6 nut with
the spanner provided.
Top Related