Installation Procedure: EVC-E2 D4/D6 Aquamatic & Inboard
IMPORTANT! Never cut or modify the Volvo Penta EVC harnesses. For extra hower supply, use the Volvo Penta relay for external accessories. Use cable ties.
To trim pump power supply
DPH connections
To POWER TRIM CONN
To trim potentiometer
Gear FWD
Gear REV
Connect shift cable. Lock cable with cotter pin. Power up before connecting shift cable to secure neutral position of actuator.
To GEARSHIFT CONN.
Shift cable bending radius max. 200 mm (8”)
Shift cable fitting down-wards. Cover upper slot with a decal
Mount actuator on transom preferably, angled 5˚ downwards
Connecting multiple Multilink hubs
Docking station DPH twin, electronic steering
Joystick
Stand-alone HCU
Multifunction panel(Docking station panel)
Stand-alone HCU connections
Buzzer
11 11
10
NMEA2000 backbone
Female terminator
Male terminator
ChartplotterEVC AutopilotCompass (CCU)EVC Autopilot
Battery 12 VDC
T-connectorBackbone ex-tension cable
Fuse
Power cable
23 20
202020Use AUX relay
24 20 22 24
Steering Control Unit (SCU)DPH twin, electronic steering
Clamp steering hoses and cables
To levers, standard EVC bus cable
To engine, ex-tension cable
IMPORTANT! The SCU can be mounted vertically or horizontally. Do NOT mount the SCU with hoses lead-ing up. This will trap air in the hydraulic valve body and cause erratic operation.
Connect power to SCU
Engine starting battery
Main switch
Fuse
Tightening torque: 5 Nm (3.7 lbf.ft)
25
Multilink hub
2.5” display
Lever connectionsLever
Buzzer
Connection for safety lanyard
Rudder angle sender
Fresh water and fuel level send-ers
Engine
Typical installationSingle engine, inboard
12
10
10
e-Key panel7
AUX bus termination
7 7 7 7
7
72
5
Example: Twin installation with (left) and without (right) accessories connected on the AUX bus
Correct!Termination in the beginning and at the end of the AUX bus
Termination plug
There is no need of termination plugs if nothing is connected on the AUX bus.
7
JoystickSteering wheel
Levers
Lever connections
Buzzer
Actuator Powertrim pump
Connection for safety lanyard
Steering Control Unit
Rudder angle sender (not used)
Fresh water and fuel level senders Engine Engine
7
12
5
2
11
10
8
7
Termination plug
MultisensorBattery
Compass (CCU)
To NMEA2000 backbone
Autopilot 4” display
7” display
e-Key panel
11
8
19
12
3131
25
Termination plug 5
7
7
11
8
Helm station
Helm station
To next helm station To next helm station
EngineEngine IMPORTANT! This end
of Y-connector must be connected directly, without extension, to levers/HCU.
Y-connector
Multiple helm stations 8
8
8
8
77
11 11
11 11
Buzzer
Connection for safety lanyard
Analog Key
Analog key interface (optional)
Typical installation / Main stationDPH twin, electronic steering
JoystickSteering wheel Multilink hub
Multifunction panel(Start/Stop panel)
2.5” displays
Levers
Lever connections
Buzzer
FlybridgeDPH twin, electronic steering
11 11
10
10
1010
10
Autopilot 4” display
To NMEA 2000 backbone
20
IMPORTANT! Maximum cable length between Multil-ink hub and unit (display etc.) is 3 m (10 ft). Maximum total cable length on Multilink is 20 m (66 ft).
2020
10 10
9
Multilink hub
Color coded cable Interceptor server unit
Interceptor Control Module (ICM)
Interceptor server unit
1
7 7
33
Multisensor
Installation Procedure: EVC-E2 D4/D6 Aquamatic & Inboard
Document number: 47704055
Release date: 05-2013
Display optionsSingle Twin
2,5” display 2,5” display
4” display 4” display
7” display 7” display
MIN MIN
MIN MIN
MIN
MAX
MAX
MAX
MAX
MAX
MAX
32. e-Key extension cable, 12-pin
Feet Meter Part no.
4.7 1.44 22067251
33. Stbd. AKI, 4/8-pin
Feet Meter Part no.
0.6 0,2 21421946
47
70
40
55
05
-20
13
Components and Cables
SteeringControls
1b. Wiring harness, Reverse gear / Inboard
Feet Meter Part no.
1 0.3 21865858
Cables
1a. Wiring harness, Stern drive / AQ
Feet Meter Part no.
12.5 3.8 21865856
2. Multisensor Y-split*
Feet Meter Part no.
1.9 0.6 21825662
*) Wiring harness AUX-bus.
24. NMEA2000 Termination plugs
Type Part no.
Male 21812196** Female 21812203**
23. NMEA2000 Powercable
Feet Meter Part no.
6.6 2 21812205**
22. NMEA2000 T-connector
Part no.
21812195**
**) Incl. in Autopilot kit
19. Display cable, 5/6-pin
Feet Meter Part no.
5 1.5 21640400
Incl. in display kit
20. NMEA2000 Extension cable
Feet Meter Part no.
1 0.3 21812185 6.6 2 21812194** 13 4 21867150 19 6 21867151 33 10 21867152
17. Steering adapter, 12/6-pin
Feet Meter Part no.
0.6 0.2 21421945
18. Y-split multilink, 6-pin
Feet Meter Part no.
1.6 0.5 3588206
11. Extension cable, 6-pin
Feet Meter Part no.
5 1.5 3889410 10 3.0 3842733 16 5.0 3842734 23 7.0 3842735 30 9.0 3842736 36 11.0 3842737 66 20.0 21172469 131 40.0 21172470
16. Extension cable, 3-pin EasyLink
Feet Meter Part no.
3 1.0 874759 10 3.0 3807043
12. Sender cable, 6-pin
Feet Meter Part no.
16 5.3 3807229
15. Extension cable, 6-pin
Feet Meter Part no.
5 1.5 21480272
13. Aux. relay cable, 6-pin
Feet Meter Part no.
3.3 1.0 21427463
Kit with cable & relay 12V: 21475508 24V: 21475509
14. Extension cable, 6-pin
Feet Meter Part no.
23 7.0 21166002 30 9.0 21166003 43 13 .0 21166004
7. Standard EVC bus cable, 6-pin*
Feet Meter Part no.
5 1.5 21865234 16 5.0 874789 23 7.0 889550 30 9.0 889551 36 11.0 889552 42 13.0 888013
*) One cable per engine has to be ordered.
8. Y-connector, 6-pin
Feet Meter Part no.
1.6 0.5 3588972
10. Multilink cable, 6-pin
Feet Meter Part no.
5 1.5 3886666
6. Y-split steering, 6-pin
Feet Meter Part no.
1.3 0.4 21421941
9. 7” display cable, 6-pin
Feet Meter Part no.
5.5 1.7 21514712*
*) Incl. in display kit
5. Termination plug
Part no.
21825714
Components
Autopilot interface NMEA 0183 interface NMEA 2000 interface
Part no. 0183 3807587 Part no. 2000 3889758
7” display power supply for 12 V systems
Part no. 21379779
SCU
Steering Control Unit
e-Key
Part no. 21758351
Compass (CCU)
Part no. 21812209
25. e-Key harness with Safety lanyard
Feet Meter Type Part no.
5 1.5 Single panel 21693202 5 1.5 Twin panel 21693206
26. e-Key harness without Safety lanyard
Feet Meter Type Part no.
5 1.5 Single panel 21693204 5 1.5 Twin panel 21693208
Multisensor
Hull mounted
Part no. 3587054
Autopilot 4” display
Color display
Part no. 21812273
31. Interceptor servo cable
Feet Meter Part no.
13 4 21875632 Incl. in Interceptor kit:
Interceptor system Interceptor and servo unit
Kit IS 600 : Part no. 21875622 Kit IS 750 : Part no. 21875623 Kit IS 900 : Part no. 21875624 Kit IS 1050 : Part no. 21875625
Interceptor Control Unit (ICU)
Manual: 21888398 Auto/Manual: 21875631
Twin engine levers
Built-in HCUs
Part no. 21856280
Single engine lever
Built-in HCU
Part no. 21856279
Single engine lever
Built-in HCU Powertrim control Side mounted
Part no. 21856288
Single engine lever
Built-in HCU Powertrim control
Part no. 21856261
Single engine lever
Built-in HCU Side mounted
Part no. 21856291
Twin engine levers
Built-in HCUs Powertrim control
Part no. 21856274
Joystick
Incl. cables 1.5 m (5 ft.)
Part no. 21846898
Steering wheel tilt adjuster
Part no. 21581323
Steering wheel hub
Incl. cables 2.5 m (8 ft.)
Part no. 21469560
2.5” display
Not in combination with 4” or 7” display
Kit no. 21846916
Multifunction panel
Function configured at startup
Kit no. 21846926
e-Key panel
Ignition, start/stop and locking/unlocking the boat system.
Single panel Part no. 21758304 Twin panel Part no. 21836809
Stand-alone HCU
Part no. 21856286
Multilink hub
6 cable sockets
Kit no: 21469055
7” display
Color display
4” display
Color display Not in combination with 2.5” or 7” display
Kit no. 22080265
Not in combination with 2.5” or 4” display
Kit no. 22080260
Rudder angle sensor
3–180 ohm
Kit no. 3889099
A-CAN
Analog lever interface
Kit no. 21460908
Multisensor
Transom mounted
Part no. 3587055
Sender
Fuel level sender 3–180 ohm
Part no. 21575479
Sender
Water level sender 3–180 ohm
Part no. 3809098
Top Related