Installation of Husqvarna
foot peg
1. Remove cotter pin from bottom of existing pivot pin.
2. Remove pivot pin allowing
you to remove stock foot peg
and spring.
It may be necessary to use needle nose pliers or something
similar to push the pin out.
Be prepared for the spring to pop out of its slot once the pin is removed.
3. Use pliers and a strong
cable tie to compress the
spring so that the legs are at a 45° angle or
less.
4. Set foot peg spring in slot of new foot peg.
5. Hold foot peg with spring in mounting bracket.
6. Slide pin through mount, foot peg, and spring.
7. Re-install cotter pin on
bottom of pivot pin.
www.knightdesignllc.com · (541) 286-4455
Copyright ©2016 Knight Design LLC. All rights reserved.
8. Clip and remove cable tie.
Adjust brake and shift levers as needed for comfort, checking that brakes and brake light work prop-erly after adjustment. Please ride with caution until you are accus-tomed to your new foot peg and
lever positions.
All done!
Top Related