Chapter 7 - Wireless Networks 1
Chapter 7
Wireless Local Area Networks Some new material added!
Chapter 7 - Wireless Networks 2
Introduction WLANs serve same purpose as LANs
Connect a set of wireless computers into a wired network
But can extend a LAN where it is not previously wired therefore making casual connections possible
Aka WiFi – used by 90% of companies This chapter looks at the data link layers
and physical layers of several technologies
Chapter 7 - Wireless Networks 3
I. Wireless Ethernet (802.11b/g) WLAN topology looks like wired star
with access point at center as hub Can apply security settings: encryption 802.11b – up to 11 Mbps 802.11g – up to 54 Mbps Central access point is a radio
transceiver that communicates like hub It is a repeater to all clients connected Can also be connected to wired network
Chapter 7 - Wireless Networks 4
Access Point Home models are usually wireless
routers. Act as access point, wired switch, and
firewall, NAT WAN port; LAN ports; wireless ports
Business models are access points connected to a central management pt
ISU uses Cisco access points ~$600
Chapter 7 - Wireless Networks 5
802.11b/g technology 3 radio frequencies used on 2.4 GHz
Same band as cordless phones and some microwave ovens
Can cause problems in apartment-type living NIC listens (CSMA) to find strongest
channel (may hear several APs) As user roams through the network, NIC
may reselect a different AP. We can stay connected from COB to HMSU!
Chapter 7 - Wireless Networks 6
More Technology Antennas – Fig 7.3 p. 225
Directional – narrower, more focused Omnidirectional – all directions
Size of antenna “cloud” affects How well users are picked up Security – does signal reach outside bldg?
802.11g can “shift down” to 802.11b but all clients must be b in low-end APs
Chapter 7 - Wireless Networks 7
Wireless Adapters PC Card – Fig 7.2.
Laptop slot miniPCI card – fits
inside laptop with antenna around the screen: better!
USB adapter – good for desktops or laptops
Connector for antenna
Chapter 7 - Wireless Networks 8
Wireless Connection Types
Infrastructure (access point) Ad Hoc (computer to computer) Any available network (AP
preferred)
If you choose the wrong type, it will not work!
Chapter 7 - Wireless Networks 9
Media Access Control Distributed Coordination – each computer
listens to see if channel is open Not good for wide networks where computers
at edge may not be able to hear each other Point Coordination – each computer sends
a request to send (RTS) to the AP, then it allows one to talk.
Efficiency – capacity is shared by all active computers on the network (e.g., 11/2 = 5.5)
Chapter 7 - Wireless Networks 10
Speed on 802.11b/g 802.11b=11 Mbps, 802.11g=54 Mbps (shorter
range) Actual speed depends on …
Signal strength effects of range up to 200+ feet without obstructions Practical is 15-50 feet with obstructions: experiment! 802.11g is shorter range than 802.11b
Trans. errors (distance, obstructions, quality of antennas) Traffic effects on speed
802.11b: low (4.8), moderate (1.9), or high (960K) 802.11g: low (17.2), moderate (6.9), high (3.4)
Super G = version of 802.11g at 108 Mbps Aka Wireless-G Enhanced
Chapter 7 - Wireless Networks 11
Physical Design Concerns
Engineering is necessary! Cathy’s older sorority house ISU wireless project used engineering
Then did reengineering when the assumptions changed (to cover faculty offices)
Antenna design makes a big difference
Hand-off issues for mobile users
Chapter 7 - Wireless Networks 12
Configuration/Security For a client to connect to an access point,
must know the … SSID of access point (Service Set ID)
Broadcast SSID (anyone can see it) Silent SSID (client must already know it)
WEP key (wired equivalent privacy Encryption) This seems like a good idea but it can be quickly
broken ala Enigma Machine (periodic status reports allow working backward to get the WEP key)
Store up to 4 WEP keys
Chapter 7 - Wireless Networks 13
Pre-Windows XP Client First install
Driver for wireless adapter Client software for the wireless NIC
Next attach the wireless adapter Configure the client SW for connection
for each access point set SSID (network name) WEP (key) if enabled
Can also configure for “choose any AP”
Chapter 7 - Wireless Networks 14
Windows XP Client Install driver for wireless NIC and install adapter Use Windows XP client software – built-in
wireless client (it disables legacy client software)
Properties of the wireless NIC connection Use the Wireless Networks tab Can set up preferred networks in your order You’ll get a message when an AP is in range Advanced: enable 802.1x authentication (802.11i)
Look for connection status in the tray: signal strength color bar (red – yellow – green)
I have had to disable the wireless bridge (???)
Chapter 7 - Wireless Networks 15
II. Wireless 802.11a (newer) Speedy: 802.11a – up to 54 Mbps! This is newer than 802.11b Operates in the 5.0 GHz range
Frequency relatively free from interference (unlike 802.11b)
http://www.networkcomputing.com/1201/1201ws1.html gives technical details about frequencies of .11a and .11b
A has more channels (4-12) than B (3) so could have more APs in a given location for more bandwidth
Each channel has 52 subchannels Media access control and packet layout similar to
B
Chapter 7 - Wireless Networks 16
III. Bluetooth (802.15) Wireless Personal Area Network (WPAN) Strikingly different purpose
Provide very small area wireless (<30 ft) Connects two devices rather that to wired LAN Replace short cable between computer and printer,
PDA and cell phone, etc. Speed is 1 Mbps – slow but OK Up to 8 devices connected; mostly 2 Not intended to do general networking
Named after Danish King Bluetooth (really!)
Chapter 7 - Wireless Networks 17
IV. Other Wireless Infrared – requires direct line of sight
New version can bounce off walls, not direct line of sight, but only in same room
Infrared used for printers, Palm Pilot PDAs, others
802.11g – long distance (MAN) Joink Fixed wireless – 2-10 mile
range at DSL like speeds
Chapter 7 - Wireless Networks 18
V. Best Practice WLAN Design Tradeoff: data rate and cost
See Fig 7.12 p. 242 on data rate and users See Tech Focus 7-1 p. 243 on distance and
speed Don’t forget the very high cost of
installing wiring vs. wireless Need for engineering approach
See Fig 7.13, 7.14 p. 246 for antenna layouts We look like Fig 7.14 in COB See Fig 7.15 p. 249 for coverage at IU Reexamine usage levels for better placement
Chapter 7 - Wireless Networks 19
WLAN Security issues !!
Assume these networks are not secure
Ways to improve security Don’t broadcast SSID Use WEP
Change SSID and WEP keys frequently Can use EAP – extensible authentication
protocol where keys are produced dynamically for each session, then discarded
Chapter 7 - Wireless Networks 20
More WLAN Security Issues Turn off remote management (like mine) so
nobody can get in and change things Change the admin password in the web server
section Consider VPN client only for access Establish rules on who can connect when
Can use MAC addresses (but users can spoof an IP) Use authentication – 802.11i
Disable DHCP and preset IP addresses on certain machines – smart and easy.
Adjust router location to reduce outside footprint
Chapter 7 - Wireless Networks 21
802.11i – Future Standard This adds client authentication to AP
role along with changing keys WPA – WiFi Protected Access (scaled down)
Temporal Key Integrity Protocol WPA fixes WEP’s problems by rotating keys
RSN – Robust Security Network (.11i) Dynamic negotiation of authentication and keys Improves on WPA Radius server does the authentication (AP talks to
it)
Top Related